What should oil pan torque settings be on Yukon?
I’m having the same exact problem after replacing the oil pan gasket on my 5.3l Yukon. I torqued all of the oil-pan to engine bolts to 89 in-lb, including the two longer bolts at the bell-housing end (Haynes Manual was not very clear).
What is the torque spec on a 5.3 oil pan?
The rear of the cover is 106 in-lbs, to engine and front cover is 18 ft-lbs and the bolts to the bell housing, bolts to the transmission and converter cover are 37 ft-lbs. Thanks. So I think I got it. I looked at it today.
How to change the oil pan gasket on a Silverado?
Its not that difficult to change the oil pan gasket even on a 4wd. Here are some steps: – remove the skid plate if equipped. – remove the starter, 2 bolts. you have to get it in the perfect angle to get it off. You may have to loosen the plastic trans cover at this point. (1 bolt below the starter I believe 10mm)
How to fix oil leak on Silverado Sierra?
– place the new gasket on the pan and place a 3/16 by 1 inch long bead of RTV on all 4 corners between the corner bolt holes. – reassemble is opposite of the above. Buy a chiltons manual, there is a sequence to torquing the pan bolts.
I’m having the same exact problem after replacing the oil pan gasket on my 5.3l Yukon. I torqued all of the oil-pan to engine bolts to 89 in-lb, including the two longer bolts at the bell-housing end (Haynes Manual was not very clear).
The rear of the cover is 106 in-lbs, to engine and front cover is 18 ft-lbs and the bolts to the bell housing, bolts to the transmission and converter cover are 37 ft-lbs. Thanks. So I think I got it. I looked at it today.
Its not that difficult to change the oil pan gasket even on a 4wd. Here are some steps: – remove the skid plate if equipped. – remove the starter, 2 bolts. you have to get it in the perfect angle to get it off. You may have to loosen the plastic trans cover at this point. (1 bolt below the starter I believe 10mm)
How do you tighten a GMC oil pan?
Tighten them all as much as you can by hand. Then tighten the middle section. Then go back and forth away from the center. One set of two on the left of the center bolts, then the right, and back and forth until you’ve reached the end.
Tighten them all as much as you can by hand. Then tighten the middle section. Then go back and forth away from the center. One set of two on the left of the center bolts, then the right, and back and forth until you’ve reached the end.
How often does a 5.3L oil pan drop?
But every 2-3 days the drivers side bolt on the tranny has a full drop on it, along with some leaking from the center hole in the tranny housing. But the oil filter is dry and clean. I have 155,000 miles and have changed out the intake this past summer.
But every 2-3 days the drivers side bolt on the tranny has a full drop on it, along with some leaking from the center hole in the tranny housing. But the oil filter is dry and clean. I have 155,000 miles and have changed out the intake this past summer.