Where are the oxygen sensors on a Kia Spectra?
Your 2009 Kia Spectra has two oxygen sensors. One sensor is located under the hood on the exhaust manifold and is referred to as the “upstream sensor” or “Sensor No. 1.” The other sensor is located under the vehicle to the rear of the catalytic converter and is referred to as the “downstream sensor” or “Sensor No. 2.”
How to replace Kia O2 oxygen sensor Bank 1?
One is upstream of the catalytic converter, and one is downstream. In the following tutorial, we will show you how to replace the upstream sensor (Bank 1 Sensor 1). The procedure is the same for the downstream O2 sensor (Bank 1 Sensor 2).
How do you replace an oxygen sensor in a car?
Spray the sensor base with some penetrating oil and let soak for five minutes. Slide the oxygen sensor wiring harness from the connector bracket. Disconnect the oxygen sensor connector from the engine wiring. If replacing the upstream oxygen sensor the bolts from the heat shield.
What’s the best way to replace a car sensor?
Depending on your fault codes or symptoms you may be replacing one or both sensors. Raise the front of the vehicle with a jack and place jack stands under the flats on the subframe rails. Lower the vehicle onto the jack stands. Spray the sensor base with some penetrating oil and let soak for five minutes.
Your 2009 Kia Spectra has two oxygen sensors. One sensor is located under the hood on the exhaust manifold and is referred to as the “upstream sensor” or “Sensor No. 1.” The other sensor is located under the vehicle to the rear of the catalytic converter and is referred to as the “downstream sensor” or “Sensor No. 2.”
One is upstream of the catalytic converter, and one is downstream. In the following tutorial, we will show you how to replace the upstream sensor (Bank 1 Sensor 1). The procedure is the same for the downstream O2 sensor (Bank 1 Sensor 2).
Spray the sensor base with some penetrating oil and let soak for five minutes. Slide the oxygen sensor wiring harness from the connector bracket. Disconnect the oxygen sensor connector from the engine wiring. If replacing the upstream oxygen sensor the bolts from the heat shield.
Depending on your fault codes or symptoms you may be replacing one or both sensors. Raise the front of the vehicle with a jack and place jack stands under the flats on the subframe rails. Lower the vehicle onto the jack stands. Spray the sensor base with some penetrating oil and let soak for five minutes.