Do you need torque specs for intake manifold?
I need the torque specs on this guy, I been looking around and can’t seem to find the specs for a 5.3, I doing this tomorrow “Saturday” and I need the specs so I now I have the correct seal for the new intake gaskets so it don’t leak on me like it is now. Thanks in advance. Randy. 44 in lbs first pass and 88 second pass.
How big is the intake manifold on a GMC Truck?
44 in lbs first pass and 88 second pass. Click to expand… It’s amazing what Google can do am I right? and keep that foam out. Silicone around the knock sensor boot Click to expand… Do you mean putting new gaskets or something else, a 5.3 is still new to me even though I have had it since May. Sexually identifies as a shopping cart.
When to tighten intake manifold bolts on 98 Chevy 350 vortex?
At what torque must the Intake Manifold Bolts be tightened to on a 98 Chevy 350 Vortex Two years post replacement the manifold seems to be leaking again?
Why is my Vortec intake manifold torquing so bad?
The clamping bolts bordering that coolant port causes too much localized pressure (imo). I think shearing forces from initial installation or heat cycles are causing this. There is also deformation/damage at other areas away from coolant but not as dramatic. Why not RTV the whole thing and forget about crappy gaskets.
I need the torque specs on this guy, I been looking around and can’t seem to find the specs for a 5.3, I doing this tomorrow “Saturday” and I need the specs so I now I have the correct seal for the new intake gaskets so it don’t leak on me like it is now. Thanks in advance. Randy. 44 in lbs first pass and 88 second pass.
44 in lbs first pass and 88 second pass. Click to expand… It’s amazing what Google can do am I right? and keep that foam out. Silicone around the knock sensor boot Click to expand… Do you mean putting new gaskets or something else, a 5.3 is still new to me even though I have had it since May. Sexually identifies as a shopping cart.
How big is the Vortec intake manifold bolt?
41 492 55.59 Vortec – Intake Manifold Bolts – VIN Z – LOWER REAR ONLY Type: Bolt 11 132 14.91 Vortec – Intake Manifold – 3 Steps: 2 FtLbs; 9 FtLbs; 11 FtL
How much torque does a small block intake have?
Small Block Chevy Intake Manifold Bolt Torque Specifications. 25 Ft/Lbs. Make sure you follow the sequence in a couple of steps, worry about this more on old and aluminum manifolds. Cast Iron is much more forgiving if you are unfortunate to have to use a boat anchor of an intake.