How do you turn off the tire pressure light on a Kia Rio?
Reset the sensor by driving at or above 50 mph for around 10 minutes. Doing so should reset it the next time you turn on the vehicle. Turn the vehicle off, then turn the key to its “On” position without starting the engine. Hold the TPMS reset button until the tire pressure light blinks three times.
What is the tire pressure for a Kia Rio?
Kia Rio Tyre Pressure
| Tyre size | Passengers | Pressure: rear |
|---|---|---|
| 185/65R15 88H | 1-3 | 215kPa 31psi 2.15 bar |
| 185/65R15 88H | 3-5 | 250kPa 36psi 2.5 bar |
| 195/55R16 87H | 1-3 | 215kPa 31psi 2.15 bar |
| 205/45R17 88V | 3-5 | 260kPa 38psi 2.6 bar |
How to check tyre pressure in Kia Rio?
Kia Rio tyre pressure warning light 1 Inflate tyres to correct pressure 2 Start the engine, make sure the vehicle is not moving and press the TPMS switch for over 3 seconds 3 Check if the warning indicator blinks for 4 seconds 4 You may get a message on the cluster saying “”tyre pressures stored””� More …
Why does the warning light go out on my Kia Rio?
Kia Rio Electronic Power Steering (EPS) is a system that uses sensors and motors to facilitate the operation of the steering wheel. The system sometimes overheats due to excessive operation from full lock to lock. If the failure is temporary, the warning light will go out when the system has cooled down.
Why is my tire pressure warning light on?
Tires will naturally lose 1-1.5 pounds of pressure each month, so if you haven’t been checking on them regularly, your warning light is probably on for a good reason. If it’s been five months since you last checked your tires, you could be running 7-8 psi below normal.
How long does it take for Kia Rio tyre sensor to reboot?
Thanks in advance. You did not say if you have driven far with the new tyres. The sensors take up to 10 miles to realign after change of tyre or pressure change. They are a bit sensitive to damage but hopefully they will reboot and you should have no problem. Mine were damaged when I bought the car and were replaced under warranty.
Kia Rio tyre pressure warning light 1 Inflate tyres to correct pressure 2 Start the engine, make sure the vehicle is not moving and press the TPMS switch for over 3 seconds 3 Check if the warning indicator blinks for 4 seconds 4 You may get a message on the cluster saying “”tyre pressures stored””� More
Kia Rio Electronic Power Steering (EPS) is a system that uses sensors and motors to facilitate the operation of the steering wheel. The system sometimes overheats due to excessive operation from full lock to lock. If the failure is temporary, the warning light will go out when the system has cooled down.
Tires will naturally lose 1-1.5 pounds of pressure each month, so if you haven’t been checking on them regularly, your warning light is probably on for a good reason. If it’s been five months since you last checked your tires, you could be running 7-8 psi below normal.
What to do if your Kia tire pressure sensor is not working?
If the TPMS sensor on the original mounted wheel located in the spare tire carrier still activates, the tire pressure monitoring system may not operate properly. Have the tire with TPMS serviced or replaced by an authorized Kia dealer. You may not be able to identify a low tire by simply looking at it.