How to turn on low beam on Kia Sorento?
Turn the low beam on with driver seated in the vehicle. The cut-off line should be projected in the allowable range shown in the picture. In case of equipping with the manual leveling device, set the leveling device switch on the “O” position.
Where are the adjustment screws on a Kia Sorento?
Open your hood and locate the vertical and horizontal adjustment screws. The vertical adjustment screw will be located on the back of the headlight, on the inside of the upper headlight, while the horizontal adjustment screw is on the “inside” of the headlight housing toward the nose of the hood.
How to adjust the fog lamp on a Kia Sorento?
The front fog lamps should be aimed as the same manner of the head lamps aiming. With the front fog lamps and battery normal condition, aim the front fog lamps by turning the adjusting gear (A). When aiming the front fog lamp, the fog lamp can be adjusted in front of vehicle without removing the front bumper.
How to put a head lamp on a Kia Optima?
1. Inflate the tires to the specified pressure and remove any loads from the vehicle except the driver, spare tire, and tools. 2. The vehicle should be placed on a flat floor. 3.
How to adjust head lamp aiming on Kia Sorento?
If there are any regulations pertinent to the aiming of head lamps in the area where the vehicle is to be used, adjust so as to meet those requirements. Alternately turn the adjusting gear to adjust the head lamp aiming. If beam-setting equipment is not available, proceed as follows : 1.
Open your hood and locate the vertical and horizontal adjustment screws. The vertical adjustment screw will be located on the back of the headlight, on the inside of the upper headlight, while the horizontal adjustment screw is on the “inside” of the headlight housing toward the nose of the hood.
1. Inflate the tires to the specified pressure and remove any loads from the vehicle except the driver, spare tire, and tools. 2. The vehicle should be placed on a flat floor. 3.
Where is the adjustment screw on a headlight?
The vertical adjustment screw will be located on the back of the headlight, on the inside of the upper headlight, while the horizontal adjustment screw is on the “inside” of the headlight housing toward the nose of the hood.