How much torque does a torque rod have?
Rated at 280,000 p.s.i., these bolts are corrosion resistant, nonmagnetic and deliver ultimate clamping capabilities for the highest cycle life. Specify desired rod bolt part number when ordering. Proper bolt torque: Torque rod bolts to 10 ft lbs on both sides, then torque to proper spec with one pull. “RBT” Steel Billet Connecting Rods
What makes a Crower connecting rod so good?
Crower connecting rods incorporate an “I-beam” design that eliminates pockets of excess material and delivers exceptional longitudinal and horizontal strength. The cap screw design assures true roundness and a positive bearing seat under severe load factors, in which eliminating rod bearing failure.
Which is the lightest connecting rod on the market?
RADIAL BEAM TECHNOLOGY (“RBT”) MAXI-LIGHT DESIGN Crower’s exclusive “RBT” Maxi-Light design is a revolutionary new beam shape that removes excess material from noncritical stress areas for the lightest, yet strongest connecting rod available on the market.
Which is the best way to test a rod?
An extensive effort in CAD (Computer Assisted Design) & F.E.A (Finite Element Analysis), as well as rigorous dyno and track testing have been expended through perfection of our strongest yet lightest rods available. When you employ a set of genuine Crowerods you do so with the knowledge and peace of mind that each rod will perform flawlessly.
What are proper torque specs for rod bolts?
Click Here for Proper Torque Specs for Rod Bolts C22105 HONDA H-BEAM K20 139MM BLT160-38 ARP 2000 C22105-CA HONDA H-BEAM K20 139MM CUSTOM AGE BLTC160-CA CA625 C23101 MITSUBISHI H-BEAM 4G63 150MM BLT160-38 ARP 2000 C23101-CA MITSUBISHI H-BEAM 4G63 150MM CUSTOM AGE BLTC160-CA CA625
What do I need to know about connecting rods?
The following information is vital for the proper connecting rod assembly installation. Please read this entire page before starting to install your rods. STEP 1: Your Crower connecting rods came with a connecting rod specification tag. Check the tag to find the rod bolt part number used to fasten your connecting rods.
How do you Torque a roller lifter rod?
Using the above table, torque the rod bolts to achieve the required amount of stretch for your application. Record this torque spec as this is the exact torque spec that you will be using to install your rods in the motor.
Where do I find the rod bolt part number?
Check the tag to find the rod bolt part number used to fasten your connecting rods. Rod bolt length listed here is the measurement from under the head to the end. STEP 2: Use the chart below to determine the recommended lubricant, rod bolt stretch and torque amounts.