What should the ground voltage be on an onallcylinder?
If you have a reading less than five ohms, the ground is okay. If the resistance is okay but the accessory still isn’t working right, set the voltmeter to DC current (voltage). Turn the accessory on and retrace the grounding path as you did before. The voltage should be no greater than .05 volts under load.
How can you tell if a spark plug wire is bad?
In addition, the engine light coming on or visible damange to the cables can be signs of a failing wire. Be sure to first check spark plug wires for visual damage. Look for any signs of melting or cracking. The following situations call for immediate replacement of spark plug wires:
What does it mean when a voltage regulator reads over 14.5?
If the voltage reads over 14.5, it probably means that you have a faulty regulator. If your voltage reading is below 13.8 volts, you have a weak battery and will need to replace it soon. Read the schematics that came with the voltage regulator.
Where are the screws on an instrument cluster?
There are two screws that hold the hard circuit board to the plastic instrument enclosure. Do not try to lift the hard circuit board out just yet. The final screw holding the platic circuit board in place was in the corner and was one of 6 screws used to connect the instrument enclosure backing to the front of the enclosure.
Is the pink wire still hot in the run position?
This wire is hot in the run position and in the crank position. If the vehicle is equipped with an electronic ignition, the feed for this is still the pink wire. If this is a points distributor the pink wire still goes through the ballast resistor.
Where does the pink wire go in a car?
The pink wire travels from the pink wire on the column, through the ballast resistor and out to the coil, or ignition system. This wire is hot in the run position and in the crank position. If the vehicle is equipped with an electronic ignition, the feed for this is still the pink wire.
What kind of 9V power supply do I Need?
. TKDY Guitar Effects Pedal AC DC Adapter 9V Power Supply with 5 Way Daisy Chain Cable, Compatible with Casio Piano Keyboard Zoom Guitar Multi Effects Pedal BOSS DanElectro, UL Listed, Center Negative. . . . .
How many volts does a 6 volt fluke meter have?
A 6-volt average of 12-volts would be an on and off time of 50%, or 50% duty cycle. I put my Fluke meter on one and checked for Hz. It was all over the map, from 0.4-seconds to 1.4″ and very irratic.