What does the PIN code stand for on a Kia?
PIN code stands for of Product Identification Number code. The PIN code is a unique code for each vehicle and it is programmed into ECM at production line. PIN code is needed when the teaching new ECM and new keys, e.g. When a new key is added
How do you code the ignition key on a Kia?
Key coding procedure is available in control unit IMMO – Immobilizer from “ECU Programming/Coding” menu. Engine must be turned off. Key is turned to ON position. You will be prompted to enter a 6-digit PIN code. (eg 123456, see page 2 – PIN codes) Now you have the key in ignition in the ON position. This key is coded after clicking on “Yes” button.
What is the password for the Kia control unit?
The password is used to switch the car into Limp mode. You will be prompted to enter password, if the control unit is not a “Virgin”. The password is numeric, consisting of 4 decimal digits (eg 1234). Regarding the Virgin control unit, you are directly prompted to set a password.
How do you push the stop button on a Kia?
Hold Stop Start Button for 5 seconds with key in smart key holder. If your car does not have smart key holder, please use tip of the remote to push start/stop button. The same operation will be performed for other of smart key fobs.
What was the problem with my Kia Sedona?
They blamed it on a bad batch of gas. I then took the van on vacation and it happened again, took it to another dealership (800 miles away from home) and could not duplicate the problem either. They found the transmission was a little low on oil and thought that it was the problem.
PIN code stands for of Product Identification Number code. The PIN code is a unique code for each vehicle and it is programmed into ECM at production line. PIN code is needed when the teaching new ECM and new keys, e.g. When a new key is added
How does the computer work on a Kia Sedona?
The computer decides what spark plug firing advance to have , what fuel injector pulse to generate, and basicly it decides what ” throttle response” you are going to see. The other sensors on the motor include temperature, Barometric air pressure and crankshaft position.
Key coding procedure is available in control unit IMMO – Immobilizer from “ECU Programming/Coding” menu. Engine must be turned off. Key is turned to ON position. You will be prompted to enter a 6-digit PIN code. (eg 123456, see page 2 – PIN codes) Now you have the key in ignition in the ON position. This key is coded after clicking on “Yes” button.