Where is the EGT sensor on a p2033 engine?
This P2033 DTC refers to Bank #1 (which is the side of the engine that contains cylinder #1). The DTC P2036 is basically identical, however it is for bank 2. An EGT sensor is found on most late model gas or diesel engines.
How to check exhaust gas temp p2033?
Simply dispose of the EGT sensor and plug the resistor into the engine side electrical connector. Wrap it with tape and the computer will be satisfied that the EGT is operating properly. Have a MB S600L V12 Biturbo 2004 who have the code P2033 & P2318. Suddenly it it loose power and no kick down. No check engine lamp.
What’s the difference between p2032 and p2033 DTC?
Code P2032 is a similar code which states that the circuit shows “low” voltage. Both relate to the condition of the sensor and the correction is the same for both. This P2033 DTC refers to Bank #1 (which is the side of the engine that contains cylinder #1).
What should the EGT sensor 2 be on a Duramax?
This DTC runs continuously when the above condition is met. The ECM detects that the EGT sensor 2 is less than 0.32 volt for greater than 1 second. The ECM detects that the EGT sensor 2 is greater than 3.37 volts for greater than 1 second.
When to use fault code p2033 in OBD II?
OBD II fault code P2033 is a generic code that is defined as “Exhaust gas temperature (EGT) sensor 2, bank 1 – circuit high”, and is set when the PCM (Powertrain Control Module) detects an abnormally high voltage in control circuit of the #2 exhaust gas temperature sensor (or in the sensor itself) that is fitted to the exhaust system of bank 1.
Why do I get p2033 on my EGT sensor?
Nonetheless, some common causes of code P2033 could include the following- Damaged, burnt, shorted, disconnected, or corroded wiring and/or connectors Short circuit between the reference voltage circuit and battery positive Abnormally high system voltages, but note that this condition will be indicated by a dedicated code, or series of codes
Simply dispose of the EGT sensor and plug the resistor into the engine side electrical connector. Wrap it with tape and the computer will be satisfied that the EGT is operating properly. Have a MB S600L V12 Biturbo 2004 who have the code P2033 & P2318. Suddenly it it loose power and no kick down. No check engine lamp.
Where is the p2033 temperature sensor located on a catalytic converter?
In these cases, code P2033 will be stored as a “pending” code. Where is the P2033 sensor located? The image above shows the typical location of exhaust gas temperature sensors on either side of a catalytic converter. Note the presence of other, unrelated sensors that must not be confused with the exhaust temperature sensors.