Where is the fuel pump relay on a 2004 Kia Sedona?
it is located on the drivers side underneath the van. you have to remove it from the underside of the car. you will need a 17 millimeter socket or wrench.
Where is the fuel pump valve on a Kia?
Look for the valve located on the fuel rail above the injectors. While your assistant turns the ignition on and off, push in on the valve. If your Kia’s fuel pump is operating properly, gas should flow through the valve. If you do see gas flowing through the valve, close it quickly using a screwdriver.
Where is the gas pump on a Kia Sephia?
Replacing the gas pump on a Kia is a simple procedure because you will not need to take out the gas tank. A cover plate under the carpet in the Kia’s trunk conceals the gas pump. Simply lift up the carpet and cover plate and remove the gas pump below. “Kia Sephia/Spectra: 1994 through 2004 (Chilton’s Total Car Care Repair Manual)”; Chilton; 2006
Why does my Kia fuel pump not turn on?
You should hear the fuel pump humming; it will turn on for two seconds at a time, since the Kia’s computer will not detect the engine turning over. If you cannot hear a humming sound, then there is most likely a problem with the relay, vehicle computer, fuel pump or the fuel pump’s wiring. Turn off the Kia’s ignition and pop the hood.
Look for the valve located on the fuel rail above the injectors. While your assistant turns the ignition on and off, push in on the valve. If your Kia’s fuel pump is operating properly, gas should flow through the valve. If you do see gas flowing through the valve, close it quickly using a screwdriver.
Replacing the gas pump on a Kia is a simple procedure because you will not need to take out the gas tank. A cover plate under the carpet in the Kia’s trunk conceals the gas pump. Simply lift up the carpet and cover plate and remove the gas pump below. “Kia Sephia/Spectra: 1994 through 2004 (Chilton’s Total Car Care Repair Manual)”; Chilton; 2006
What are the components of a Kia Sedona?
1. Engine Control Module (ECM) 2. Barometric Pressure Sensor (BPS) 3. Manifold Absolute Pressure Sensor (MAPS) 4. Intake Air Temperature Sensor (IATS) 5. Engine Coolant Temperature Sensor (ECTS) 6. Throttle Position Sensor (TPS) [integrated into ETC Module] 7. Crankshaft Position Sensor (CKPS) 8. Camshaft Position Sensor (CMPS) [Bank 1 / Intake]
You should hear the fuel pump humming; it will turn on for two seconds at a time, since the Kia’s computer will not detect the engine turning over. If you cannot hear a humming sound, then there is most likely a problem with the relay, vehicle computer, fuel pump or the fuel pump’s wiring. Turn off the Kia’s ignition and pop the hood.