How can I remove a bad sway bar link?
Identify the bad link. A bad link: Remove the nut holding the sway bar link to the sway bar. You will have to grip the shaft below the sway bar so it does not turn – for example pair of vice grip locking pliers.The bottom bolt you can use a socket wrench on the nut, and a wrench on the nut on the other side of the mounting point (see picture).
Can you remove the nut from a sway bar?
Remove the nut holding the sway bar link to the sway bar. You will have to grip the shaft below the sway bar so it does not turn – for example pair of vice grip locking pliers.The bottom bolt you can use a socket wrench on the nut, and a wrench on the nut on the other side of the mounting point (see picture). Install the new link.
What are the links on a sway bar?
Be sure it is installed the same as the original – the bushings are touching the sway bar – from the top: nut, metal washer, bushing, sway bar, bushing, metal washer. The lower link is simply nut, mounting point, smaller nut.
How do I take off sway bar front bushing?
Jack the car up and shake the tire top and bottom back and forth! There should be no play. If the tire moves in and out, then you have a bad control arm bushing or even worse, a bad wheel barring. Both should be fixed asap as these are very dangerous. Thanks! How do I take off sway bar front bushings?
Where is the sway bar link on a car?
Step 6: Locate the sway bar link to be replaced. Sway bars are usually located at the front of the car and are bolted to the suspension on your vehicle. Depending on the make and model of your car, you may have only front sway bars links, or front and rear sway bar links. Step 7: Remove the lug nuts. Two lug nuts hold the sway bar link in place.
Remove the nut holding the sway bar link to the sway bar. You will have to grip the shaft below the sway bar so it does not turn – for example pair of vice grip locking pliers.The bottom bolt you can use a socket wrench on the nut, and a wrench on the nut on the other side of the mounting point (see picture). Install the new link.
Jack the car up and shake the tire top and bottom back and forth! There should be no play. If the tire moves in and out, then you have a bad control arm bushing or even worse, a bad wheel barring. Both should be fixed asap as these are very dangerous. Thanks! How do I take off sway bar front bushings?
How do you remove a tire from a sway bar?
This is important because the sway bar is a load bearing part. Setting the jack stand in this way compresses the suspension and relieves the pressure from the sway bar link. Leave the jack slightly touching the lift point while still keeping the majority of the vehicle’s weight on the jack stand. Step 5: Remove the tire.
What do I need to remove front wheel drive sway bar?
Remove the nuts holding the sway bar link to the bar and control arm. Remove the link. Link removal on some front-wheel-drive cars will require a ¼-inch Allen wrench to keep the bolt from spinning.
How do you remove a stabilizer bar from a car?
Remove the Stabilizer Bar and Link. Loosen the lug nuts on the wheel slightly. Elevate the front of the vehicle. Make sure the supports are secure before proceeding. Remove the front wheel assembly. Remove the nut and the stabilizer bar link at each side of the vehicle. Take the rear mounting bolts off the sub-frame.