Where is the purge valve on 2011 Kia Soul?
The evap canister, also known as the purge valve, on the 2011 Kia Soul is located to the left of the brake booster and master cylinder on the driver side firewall. The EVAP canister is filled with activated charcoal and is designed to catch the emissions that are put off by Your car and trap them.
Where is the purge valve located on a Kia Soul?
The purge valve is located in the vacuum line between the fuel vapor containment canister and the intake manifold. It opens at specific times to let fuel vapors stored in the canister be drawn into the intake manifold and burned as part of the combustion process.
How do I reset the check engine light on my Kia Soul?
How Do You Reset Your Check Engine Light?
- Turn off your ignition.
- Don some safety glasses and gloves.
- Locate the negative terminal.
- Loosen the negative terminal’s nut with a wrench, then pull the connector from the battery, keeping it to the side for 30 to 60 seconds.
- Reconnect the cable and tighten with your wrench.
Where is the purge valve on Kia Soul?
Kia Soul: Schematic Diagram. The Purge Control Solenoid Valve (PCSV) is installed in the passage connecting the canister to the intake manifold. It is a duty type solenoid valve and is operated by ECM/PCM signal. To draw the absorbed vapor into the intake manifold, the ECM/PCM will open the PCSV, otherwise the passage remains closed.
Where is the purge control solenoid valve in a Kia Rio?
The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PCM when appropriate conditions are set. The Purge Control Solenoid Valve (PCSV) is installed in the passage connecting the canister to the intake manifold. It is a duty type solenoid valve and is operated by ECM/PCM signal.
How is the evaporative system in a Kia Soul?
Evaporative System Monitoring Evaporative And ORVR Emission Control System This system consists of a fill vent valve, fuel shut-off valve, fuel cut valve (for roll over), two way val 1. Purge Control Solenoid Valve (PCSV) 2. Vapor line 3. ORVR valve 4. Fuel tank air filter 5.
Where is the purge control solenoid valve located?
The Purge Control Solenoid Valve (PCSV) is installed in the passage connecting the canister to the intake manifold. It is a duty type solenoid valve and is operated by ECM/PCM signal. To draw the absorbed vapor into the intake manifold, the ECM/PCM will open the PCSV, otherwise the passage remains closed.