Should I replace thermostat with timing belt?
The thermostat is cheap and if it’s near the area being worked on, it should be changed. The water pump on many engines is driven by the timing belt. Changing it with the timing belt is a very good idea, especially if the engine has over 100,000 miles on it.
How often should I replace my thermostat?
The lifespan of most home thermostats is 10 years. However, you may need to replace yours sooner as newer, more efficient thermostats enter the market. You may, for instance, want to replace a non-programmable thermostat with a programmable option.
How to replace a crankshaft position sensor [ step by step ]?
The steps provided below for replacing a crankshaft position sensor are similar for most engines.
Where is the O / T mark on the timing belt?
At TDC for cylinder number 1, the O/T mark on the crankshaft pulley timing wheel or vibration damper (green arrow) will line up with the line on the lower timing belt cover (yellow arrow). In addition, the mark on the camshaft sprocket should line up with the mark on the cylinder head.
How do you change the timing belt on a BMW?
Use a 3-millimeter Allen wrench or driver for this task. Replace the cap and rotor with new ones when replacing the timing belt. At this point, you should be able to remove the few small bolts that hold on the upper timing belt cover. The cover will slide off, and you should see the upper part of the timing belt.
What to do if your car wont start after replacing timing belt?
If these checks don’t yield any results, then you should consider contacting a professional technician, such as one available from YourMechanic, to diagnose the no start condition. The statements expressed above are only for informational purposes and should be independently verified.
How much does it cost to replace a timing belt?
Please try again later. Hyundai Crankshaft Position Sensor Replace Timing Belt Replace 2.4 Liter Four Cylinder. Crankshaft Position Sensors often malfunction after 100,000 miles on late model vehicles. The local dealer charges $400 labor to replace this very basic part.
How do you remove the timing belt on a water pump?
Remove the 4x 10mm bolts securing the fan clutch to the water pump pulley. Carefully remove the fan clutch. There will be tension on the belt, so the pulley will try to move a bit, but it shouldn’t pop off. Loosen the lock nut (12mm on the tensioner arm) and lock nut (14mm through the pulley holes) on the power steering pump.
How do you remove the timing belt on a Nissan Z32?
The crank sprocket is often stuck on the crankshaft pretty hard. A common method to remove it is to chisel it off with an air hammer. Some owners have experienced failure of stock idler studs. RameyZ sells heavy duty idler studs to prevent failure. Finally, it is highly recommended that all parts in this job are replaced with Nissan OEM parts.
When to replace the timing belt on a Hyundai?
Hyundai Crankshaft Position Sensor Replace Timing Belt Replace 2.4 Liter Four Cylinder. Crankshaft Position Sensors often malfunction after 100,000 miles on late model vehicles. The local dealer charges $400 labor to replace this very basic part.