How to replace the blower motor on a Kia Soul?

How to replace the blower motor on a Kia Soul?

1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. 3. Remove the driver’s side shower duct (A) after loosening the screw. 4. Lower the steering column after loosening the mounting bolts and nuts. 5. Disconnect the mode control actuator connector (A) and then remove the mounting clip (B).

What causes a Kia Spectra blower to work sporadically?

What could cause a blower motor in a 2006 Kia Spectra to work sporadically? This could be caused either by a weak connection at the blower motor or a dead spot inside the motor. First, confirm if there are any unattached wires and connections at the motor. Then, test the connector with a voltmeter for power, when the motor is inactive.

What to do if your Kia blower makes a squeaky noise?

If so, the best solution would be to replace the motor. Another option could be to hit the motor lightly from below the passenger side of the dash and check if it starts. What could cause a Kia blower motor to make a squeaky noise when running for the first few minutes?

What causes Kia Sedona blower to blow air only in front?

If there is power to the motor and the rest of the blower seems to work fine, it might indicate a bad field effect transistor that could be replaced to fix the issue. What could cause a blower motor to blow air only in the front of a 2007 Kia Sedona?

What could cause a blower motor in a 2006 Kia Spectra to work sporadically? This could be caused either by a weak connection at the blower motor or a dead spot inside the motor. First, confirm if there are any unattached wires and connections at the motor. Then, test the connector with a voltmeter for power, when the motor is inactive.

If so, the best solution would be to replace the motor. Another option could be to hit the motor lightly from below the passenger side of the dash and check if it starts. What could cause a Kia blower motor to make a squeaky noise when running for the first few minutes?

If there is power to the motor and the rest of the blower seems to work fine, it might indicate a bad field effect transistor that could be replaced to fix the issue. What could cause a blower motor to blow air only in the front of a 2007 Kia Sedona?

Can a faulty blower motor cause a car to start?

A faulty blower motor can cause this. Have the blower motor plug checked with a test light to ensure if there is power to it. If so, the best solution would be to replace the motor. Another option could be to hit the motor lightly from below the passenger side of the dash and check if it starts.

How does the negative side of the Kia blower work?

It works by controlling the negative side of the blower by switching it on and off, the faster it switches, the more current the motor can draw It is hard to check with a meter due to the fast switching although some higher makes like Fluke can pick up the pulses.

How is the blower fan on a Kia Sportage Gen 2?

Hi i have had some experience with the blower fan on the Sportage gen 2. One thing to note is the term resistor is a misnomer on this model and it uses a an electronic MOSFET chip to control the speed. The fan is fed with 12 volts on the positive wire all the time the ignition is on via a relay and 40 amp fuse.

When did I replace the blower on my Kia discovery?

Ok, we replaced our 25 year old Discovery with an 06 reg Sportage XE petrol, in March and we love her. Perfect for me, my old mum and for a 4×4 low enough for our dog to get in or for us to lift her in for emergency vet visits (there have been some).

What are common reasons my Kia Soul has heater problems?

What are common reasons my Kia Soul has heater problems? While there are a variety of reasons your Kia Soul heater is not working, the most common 3 are a broken heater blower motor, a problem with the thermostat, or a failed heater blower motor resistor.

Why is my Kia blower not working properly?

To do so, put one lead of the tester at the connector’s red/black stripe wire and the other to a clean metal piece to get a proper ground. If there is power to the motor and the rest of the blower seems to work fine, it might indicate a bad field effect transistor that could be replaced to fix the issue.