Why does my Kia Rio crank but not start?

If your Rio isn’t getting enough fuel, or any fuel at all, it may have a bad fuel filter, bad fuel pump, or bad fuel injectors. Without the proper amount of fuel getting into the combustion chamber, the Rio will crank, but not start. 2. Ignition Issues One of the biggest issues that causes a vehicle to crank but not start is ignition issues.

Can a bad fuel pump cause a Kia to not start?

If your Rio is difficult to start, a bad fuel pump would probably not be the place to start looking, especially if you are’t getting a fuel related trouble code. Instead, we’d recommend taking a look at the ignition system first. Often it’ll be bad spark plugs, or a bad coil pack. Engine Won’t Start

Can a Kia Rio run without a fuel pump?

Without gas your Rio will not run at all. With that in mind, most of the symptomsof a bad fuel pump revolve around the vehicle stalling out or not running at all. In modern fuel injected vehicles, the fuel pump sits right in the fuel tank and “pushes” the gasoline to the fuel rail(s).

What does a bad fuel pump sound like?

A priming fuel pump sounds like a high-pitched whine for a few seconds and can be heard with a sharp engine right after the ignition key is turned, but before the starter is engaged. Conclusion: Kia Rio Bad Fuel Pump The symptoms of a bad fuel pump match a lot of other common problems that can occur in the Kia Rio.

What happens if a Kia Rio fuel pump goes bad?

One of the worst problems that can happen to a vehicle is abad fuel pump. If your Kia Rio’s fuel pump goes bad, no fuel (or not enough fuel depending on whether or not it’s out all the way) can enter the engine. Without gas your Rio will not run at all.

What causes a car to crank but not start?

One of the biggest issues that causes a vehicle to crank but not start is ignition issues. When there is no spark, the engine will not start. You’ll probably have a misfire related code such as P0300, P0301, etc….. Ignition issues can be caused by many things, including bad spark plugs, bad coil packs, bad plug wires, computer issues, and more. 3.

Can a Kia Rio stall at any time?

Stalls can happen at any time, and it can be incredibly jarring when it does happen. Before troubleshooting any automotive issue, including stalling issues with the Rio, make sure that you check the vehicles trouble codes with an OBD2 scanner.

Why does my Kia fuel pump not turn on?

You should hear the fuel pump humming; it will turn on for two seconds at a time, since the Kia’s computer will not detect the engine turning over. If you cannot hear a humming sound, then there is most likely a problem with the relay, vehicle computer, fuel pump or the fuel pump’s wiring. Turn off the Kia’s ignition and pop the hood.

Where is the fuel pump valve on a Kia?

Look for the valve located on the fuel rail above the injectors. While your assistant turns the ignition on and off, push in on the valve. If your Kia’s fuel pump is operating properly, gas should flow through the valve. If you do see gas flowing through the valve, close it quickly using a screwdriver.

What does trouble code p0335 mean on Kia Rio?

When the Rio’s ECM determines that there is an issue with the signal coming from this sensor, it’ll throw the P0335 trouble code. Depending on the model year and engine of any vehicle the job of the crankshaft sensor is going to change.It’s either going to provide info to the ECM to keep the vehicle from misfiring.

How does the crankshaft position sensor work on a Kia Rio?

The Kia Rio utilizes a crankshaft position sensor in order to regulate the engine timing. This sensor uses a reluctor to gauge the position of the crank. When the Rio’s ECM determines that there is an issue with the signal coming from this sensor, it’ll throw the P0335 trouble code.

Why is the p0335 thrown on the road?

The crankshaft sensor is often the reason that P0335 is thrown. They aren’t very expensive, but they can be difficult to get to in order to service them. If you think you’re up to the challenge (and know how to use a volt meter) this guide from doityourself.com will show you exactly how to test the sensor.

What to do if your Kia won’t start?

Please try again later. If you are stuck in a Kia or Hyundai this video just might save you alot of trouble! The IPS Module In these Hyundai and Kia Vehicles Has a relay in there that can act like a huge problem, When all it is really is a simple relay. This is only a temporary fix btw.. Loading…

Why is my IPS module on my Kia not working?

The IPS Module In these Hyundai and Kia Vehicles Has a relay in there that can act like a huge problem, When all it is really is a simple relay. This is only a temporary fix btw.. Loading…

Why does my Kia Rio engine not start?

There are a lot of issues that can cause your Rio to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code. It is definitely worth it to use an OBDII scanner to check and see if the engine has thrown any trouble codes.

Why does my car not start when I crank the engine?

If the engine doesn’t crank, or makes an unusual noise when cranking, you may have a starting system problem. The car’s security system may have made an error that disabled the fuel or ignition system, or the chip in the key may have failed.

What should I do if my car won’t start?

Ask an assistant to turn the ignition key to the On position, but don’t start the engine. As your assistant turns the key, listen closely through the filler neck of the fuel tank. You should hear the whirring sound of the fuel pump motor being energized for two or three seconds.

What to look for when your engine won’t start?

Check for a blown fuse that may be preventing a circuit from working properly, like the fuel injection or computer system. To operate efficiently, an internal combustion gasoline engine needs a good spark, the right amount of fuel, and good compression (a healthy mechanical condition).

What is the smartra system on a Kia Rio?

1. SMARTRA type immobilizer A. The SMARTRA system consists of a transponder located in the ignition key, an antenna coil, a SMARTRA unit, an indicator light and the PCM (ECM). B. The SMARTRA communicates to the PCM (ECM) (Engine Control Module) via a dedicated communications line.

Is the Kia Rio no frills for sale?

Way cheaper than a no frills 2014 Rio -as in not even power windows- that was for sale. I really think there is a Factory defect in the 2912 and 2013 Kia Rio. This explains the low price. After reading these posts-I am convinced that the starter in 2012 and 2013 is defective.

What does it mean when Kia Rio won’t start?

The first and most common is when it won’t turn over. This just means that the engine doesn’t move when you turn the key. The second way that your Rio won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own.

What are the components of the Kia Rio?

1. Engine Control Module (ECM) 2. Manifold Absolute Pressure Sensor (MAPS) 3. Intake Air Temperature Sensor (IATS) 4. Engine Coolant Temperature Sensor (ECTS) 5. Throttle Position Sensor (TPS) [integrated into ETC Module] 6. Crankshaft Position Sensor (CKPS) 7.

Why is my Rio engine cranking but not starting?

It really can get that one last start out of it. There are a lot of issues that can cause your Rio to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code.

How to fix Kia Rio power and acceleration?

Turn all the ignition switch but do not start the car. 2. Disconnect the negative terminal from the battery for five minutes. 3. Connect the terminal back and turn the switch to the off position. 4. Start the car for 10 minutes until it reads the valve code again.

How to remove an alternator pulley on a Kia Rio?

Tool (Number and name) Illustration Use Alternator pulley remover wrench (09373-27000) Removal and installation of alternator pulley …

Where did the Kia Motor Rio stall twice?

When driving vehicle everything turns off in car and jerks and starts heading towards the right. This has happened twice on highway 395 and once on interstate 15. Also while the car is in a drive through the car has stalled more than twice.

Is the Kia Motor Rio a safety issue?

This has been happening since the beginning of November 2016 and has happened every day since then. This is a safety issue because the car could stall anytime while driving and I could be seriously hurt and other drivers could get hurt. See all problems of the 2010 Kia Motor RIO .

Why does my Kia Rio go into limp mode?

Other problems… Car goes into limp mode after driving for at least 1/2 hour and heater coolant fan refuse to work. Change engine oil temp sensors still in limp mode I have fuel in my Kia and I have a great battery in my Kia but when I turn the key switch the motor wont start if I cross the starter over the engine will start.

Why does my Kia Rio make a ticking sound?

There’s a possibility the oil pressure is low, lifters will make a ticking sound when this occurs. From my experience and others from what I’ve read these engines are notorious for sludge build up inside the engine due to perhaps low quality oils or neglect by not servicing.

Is the Kia Rio diesel a good car?

Running great now. Really light steering when going 100kms, twitchy and quite dangerous! We have a 2008 kia rio diesel with really light steering when travelling at speed. It is really twitchy and dangerous when travelling around a corner at speed, but will be good when it is travelling around the town at low speed.

What to do if your Hyundai Getz won’t start?

Check the battery and the terminal cable connections. If they look really corroded, you need to clean the battery posts and cable connectors or replace the cables and try to start the engine. Also check the starter. The solenoid attached to the top of the starter can fail, as well as the components inside.

Why is my Mercedes-Benz A180 CDI not starting?

Most commonly this could be caused by a low/dead battery or there is no connection between the battery and starter. Check the battery and the terminal cable connections. If they look really corroded, you need to clean the battery posts and cable connectors or replace the cables and try to start the engine. Also check the starter.

Why does my Kia Rio light keep blinking?

If the wrong key has been used and the code was not received or recognized by the PCM (ECM) the indicator light will continue blinking for about five seconds until the ignition switch is turned OFF. F.

What to do if your Kia Sedona is not starting?

The newest version of the smart key can be used to press the start button, which will allow the vehicle to register the key when the battery is low. If these quick tips do not allow the vehicle to start, or the vehicle does not use a smart key, diagnostics will need to be performed by a factory authorized Kia service enter.

What does immobilizer light on Kia Rio mean?

The immobilizer indicator light in the cluster will simultaneously come on for more than five seconds, indicating that the SMARTRA unit has recognized the code sent by the transponder. E.

What should the voltage of a Kia Rio battery be?

The voltage of the battery on your Kia Rio can be measured precisely with a multimeter. Before the test, the multimeter is set to the voltage range of the battery and connected to its plus and minus poles. Successful testing of the car battery, i.e. checking the voltage, usually results in values of approx. 12 to 13 volts.

How do you clean a Kia Rio battery?

To clean the battery on your Kia Rio, you have to remove the pole cables first, which requires no special knowledge, just a little concentration, as the order is very important. First remove the black cable from the negative pole. If the pole clamp is very tight, you can open it with pliers.

Why does my car not start in the morning?

It won’t start when it has been sitting all night and the next morning it is real damp outside or it has been raining. If it becomes a sunny day and everything dries, the car starts up just fine. Tried to call the manufacturer and got the run around. Going to call my local news station and let them get involved

Navigation