What are the procedures for a pressure test?
The purpose of these procedures is to ensure that pressure tests are conducted safely and effectively. They cover pressure testing of new and existing pressure systems or components at a test pressure more than 0 psig. They apply to mechanics, supervisors, inspectors, custodians, and subcontractors responsible for pressure tests. 2 Procedures
How do you install a nitrous pressure gauge?
Installation – Nitrous Pressure 1. Check that you have all parts required for installation, and the engine is cool. 2. Disconnect the negative (-) battery cable. 3. Gauge mounts in a 25⁄8” hole for 25⁄8” gauges, and a 21⁄16” hole for 21⁄16” gauges. Use supplied brackets and nuts to secure gauge to dash. 4.
Where can I find torque specifications repair guides?
We also have Repair Guides for your vehicle, simply follow the link below and enter your vehicle’s year, make, model, and engine to find the info you need to do the job right. You can also browse excerpts by subcategory: Find out how to access AutoZone’s Torque Specifications Repair Guides.
How to install full sweep electric pressure gauges?
1. Check that you have all parts required for installation, and the engine is cool. 2. Disconnect the negative (-) battery cable. 3. Gauge mounts in a 25⁄8” hole for 25⁄8” gauges, and a 21⁄16” hole for 21⁄16” gauges. Use supplied brackets and nuts to secure gauge to dash. 4.
How to diagnose a pressure sensor on a computer?
Turn the key to the on position. Disconnect the wiring to the pressure sensor. Using a wiring diagram, identify the 5V, ground and signal wires. Place the meter leads between the 5V and ground terminals coming from the computer, not the sensor. You should see very close to 5Volts. If it does go to step 8.
Is there a way to wire a pressure switch?
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: wFLEHp1B55SAJe9F)
Installation – Nitrous Pressure 1. Check that you have all parts required for installation, and the engine is cool. 2. Disconnect the negative (-) battery cable. 3. Gauge mounts in a 25⁄8” hole for 25⁄8” gauges, and a 21⁄16” hole for 21⁄16” gauges. Use supplied brackets and nuts to secure gauge to dash. 4.