How often are belts replaced?
Under ideal conditions, a belt should stick with you for an average of 60,000 to 100,000 miles. Pretty impressive. However, some belts are manually tensioned and may need to be adjusted. Others have a self-tensioning mechanism that can experience wear over time and may need to be serviced.
How long should belts last?
Mileage Indicators. Today, most serpentine belts are expected to last anywhere from 60,000 to 100,000 miles. Some belts can last significantly longer than this, while others give out before 60,000 miles. Make sure to check your owner’s manual to find out the recommended belt replacement time frame.
What belts last the longest?
Leather belts made of full grain leather are the highest quality leather belt that you will be able to purchase. It has experienced minimal alteration or separation from other parts of the original hide, which makes the color richer, the leather tougher, and its usable life much longer.
When do you need to replace a car belt?
Belts installed on vehicles with manual tension drives should be properly tensioned during installation, and re-tensioned after 5 minutes of run-in (30 lbs. per rib). A belt installed incorrectly will make noise and if not remedied quickly, will need to be replaced
When to replace a belt due to misalignment?
Inspect and replace all accessories / pulleys that are difficult to rotate (i.e. rough/seized bearings), or show excessive wobble / free rock Warning: Any existing misalignment condition probably caused pre-mature wear of the belt ribs on the old belt. A new belt is recommended once the accessory drive has been realigned.
What do I need to replace my serpentine belt?
I just got my serpentine belt replaced and it’s squealing when I start the car and sometimes when I hit the gas what is this do I need a fan belt?? My car has 134000 miles.
When to replace a tensioner on a belt?
On systems equipped with an automatic tensioner, the tensioner pulley should turn freely without binding, the tensioner arm should move smoothly through its entire range of motion and there should be adequate tension. Replace the tensioner and /or pulley as required
When did my timing belt need to be replaced?
My timing belt needed replacement at about four years, too. Drive belt was replaced at the same time. Mine is a 2002 Hyundai Accent which is still going strong at 66,000 miles. If it would only last forever. . . 32 mpg around town, 38 on the road, a manual transmission. “Whichever comes first” is definitely implied.
Belts installed on vehicles with manual tension drives should be properly tensioned during installation, and re-tensioned after 5 minutes of run-in (30 lbs. per rib). A belt installed incorrectly will make noise and if not remedied quickly, will need to be replaced
Inspect and replace all accessories / pulleys that are difficult to rotate (i.e. rough/seized bearings), or show excessive wobble / free rock Warning: Any existing misalignment condition probably caused pre-mature wear of the belt ribs on the old belt. A new belt is recommended once the accessory drive has been realigned.
I just got my serpentine belt replaced and it’s squealing when I start the car and sometimes when I hit the gas what is this do I need a fan belt?? My car has 134000 miles.