Is there a way to remove FG automatic gear selector from YouTube?
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: 4JbbsrP7rVnd4A4E) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.
How do you remove the Double Gear from a gearbox?
By twisting the upper Selector-fork so that the Operating-peg clears the cam track, the fork and the Double gear can be extracted. In a similar manner the Layshaft assembly and the lower Fork can be removed. This leaves only the Sleeve-gear, which can be tapped into the Housing through the large Ballrace.
How do you remove the cap from a gearbox?
Preliminary Work. Disconnect the Clutch Control Cable from the Handlebar-lever first and then from the connecting-piece in the Gearbox. Unscrew and remove the hexagon-headed Bearing Cap just above the Filler-plug in the Gearbox End-cover.
How do you remove a gearbox from a MOV?
Loosen the large nut thus disclosed, holding the Gearshaft from turning meanwhile by having the Rear Brake applied by an assistant. On MOV and MAC to remove the gearbox from the machine, proceed as described on page 54 to remove the Primary Chain cover, the Chain and the Clutch.
How do you adjust the gear selector on a Honda Accord?
The gear selector should move smoothly and accurately to each gear position. Adjust the shift cable in the indicator does not line-up with the position indicator while in the proper detent. To adjust, loosen the swivel nut on the shift linkage.
What do you do with the shift selector?
1. Park the vehicle on a level surface, shift to N(Neutral) and apply the parking brake. 2. Using a pushbutton shift selector,simultaneously press the UPand DOWNarrows one time. Using a lever shift selector, press the DIAGNOSTICSbutton one time. 3. The fluid level reading may be delayed until the following conditions are met: – Engine is at idle.
How do you reset the shift selector on a Weller truck?
The WRENCH ICONclears automatically when appropriate conditions are detected. Transmission Health Monitor must be reset manually using Allison DOC™ after correcting a clutch system issue. Using either a pushbut- tonor lever shift selector, perform the following shift sequence with the ignition on but the engine off.
Where can I get an Allison shift selector?
SHIFT SELECTOR P.O. Box 894, Speed Code PF3 Indianapolis, Indiana 46206-0894 www.allisontransmission.com SA3360EN (2009/10) Litho in U.S.A. ISO/QS 9000 and ISO 14001 Certified SHIFT SELECTOR OPERATION AND CODE MANUAL Oil level information, diagnostic codes and prognostic features for 3000/4000 SERIES ALLISON TRANSMISSIONS 2 The Allison Advantage