How do you reset the ABS light on a Kia Sorento?
How to Reset an Anti-Lock Brake Light
- Disconnect the positive cable from the car battery, and then hold down on the brake pedal to drain the car’s electrical system.
- Change the ABS sensor if the light comes back on.
What are the codes for an ABS warning light?
If after testing the sensor or if you have scanned the ABS computer and get a trouble code C0035, C0040, C0041, C0045, C0046, C0050, C0051, C1221, C1222, C1223, C1224, C1225, C1226, C1227, C1228 , C1232, C1233, C1234 or C1235 the sensor is either unplugged or it has shorted out and needs replacement.
Why does my abs light come on when I clean my wheel sensor?
Some of those things are serious, but oftentimes it just means you need to clean the sensors. One or more dirty wheel sensors (all cars with anti-lock brakes have at least one) can cause the system to trigger the ABS light during the computer’s self-evaluation cycle.
Why does my abs light keep coming on after I Turn Off the key?
If the ABS system stays on after the key is turned off which is indicated by a humming noise or you have scanned the system and one of the valve control coils has burned out the unit needs to be replaced. The wheel speed sensor works in conjunction with the sensor to monitor the speed of rotation of the wheel.
Can you reset the ABS light without scan tool?
How to reset ABS light without scan tool; this is what you need to know! Every time you ignite your car, the ABS light, alongside other lights on your dashboard, will always turn on. This is perfectly normal, and it means that the light bulbs are functioning as they should.
What does the code c1206 mean on ABS?
C1206 Meaning. The Anti-Lock Brake System (ABS) Module monitors the ABS Rear Isolation Valve. The ABS Module sets the OBDII code when the ABS Rear Isolation Valve is not to factory specifications.
What to do if ABS wheel speed sensor goes out?
If the ABS wheel speed sensor was faulty, once the new hub/sensor is installed, and you drive the vehicle, the warning lights should go out. To determine what is going on, you can manually erase the trouble codes using an appropriate scan tool and if the warning lights stay off, then the problem is resolved.
What should I do if my abs light is not working?
The ABS relay should also be examined and replaced. Attach a voltmeter set up to the sensor and spin the wheel or hub to produce voltage. The voltage should increase and decrease according to the speed of the wheel or hub. But if the sensor failed to record this, it must be replaced.
How to find out if your car has a c1206 code?
Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost to diagnose the C1206 code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.