How big are the ring gear bolts on a Chevy Silverado?
Tighten the NEW ring gear bolts. • For the 8.6 inch axle, tighten the ring gear bolts in sequence to 120 N·m (89 lb ft). • For the 9.5/9.5LD inch axles, tighten the ring gear bolts in sequence to 140 N·m (103 lb ft). • For the 11.5 inch axle, tighten the ring gear bolts in sequence to 237 N·m (175 lb ft). Install the pinion bearing cups.
What are the specs for ring and pinion gear?
10 bolt cover with a 12 bolt carrier. 8.875″ ring gear. 31 spline bolt in axels. 28 spline pinion. note, this is NOT an “O” diff setup. If you are talking about the pinion nut it is not hand tighten. The spec measures the torque required to turn the pinion gear by itself once the nut is tightened.
What are the torque and backlash specs for Ring?
Ring gear set up data is ©Copyright Crawlpedia.com – Please provide a link back to this page when copying. Data is accurate to the best of our knowledge through 2013 and is offered as-is with no guarantee. Chrysler Axles- Gear Setup Torque and Backlash Specs:
How big is a carrier side adjuster tube?
Axle Tube Diameter: Ø2.500″ Pinion depth: 4.124″ Carrier side adjuster torque for carrier preload (before caps are fully torqued): 100 ft*lb Axle tube diameter: 3.000″ Ford / Sterling 10.25″ / 10.5″ Rough start for crush sleeve eliminator / solid pinion spacer: .835″
10 bolt cover with a 12 bolt carrier. 8.875″ ring gear. 31 spline bolt in axels. 28 spline pinion. note, this is NOT an “O” diff setup. If you are talking about the pinion nut it is not hand tighten. The spec measures the torque required to turn the pinion gear by itself once the nut is tightened.
What do you need to install ring gear?
The first thing to do when beginning any project is to make sure you have all the required parts: ring gear, pinion gear, differential, four tapered roller bearings each consisting cup and cone, shims and of course the necessary hardware to bolt everything together.
What to do with a ring gear spacer?
If a ring gear spacer is to be used, also check it for surface imperfections. Nicks or burrs can be removed by using block-backed grit paper or a small file. Following material removal, rewash in solvent and air dry. Mount ring gear.
How do you install ring gear on a Dana 60?
Install the cone carrier bearings and ring gear onto the differential, again using proper fixtures being careful not to damage the bearings. Install ring gear bolts with a six point socket and torque. You MUST use red Loctite or equivalent thread locker on the threads of these bolts.