Where is the OBD2 plug on a jeep KK?
OBD2 port Jeep Cherokee KK (2008 – 2013) – Find your plug ! Where is my OBD2 port ? All vehicles are equipped with an OBD port to which you can connect your klavkarr diagnostic case.
What are the pins for the OBD-2 connector?
OBD-2 connector must have pins 4, 5 for ground connections and pin 16 for 12 volt power supply from the vehicle battery. What is OBD DTC? Prior to OBD, auto manufacturers did not standardize DTC’s (diagnostic trouble code).
What is the location of the OBD port?
The OBD Port, is the location where you can plug in any OBD tool into the vehicle to pull vehicle information. It is also the primary location of tracking devices such as dongles as the port provides ongoing power to the device. There are two generations of OBD ports, OBD1 and OBD-ii aka OBD2.
How does the OBD-2 diagnostic interface work?
If the vehicle’s onboard diagnostic system detects a malfunction, a DTC corresponding to the malfunction is stored in the vehicle’s computer, as well as realtime data from the sensors connected to the on-board computer. In addition, the OBD-II interface provides a means to clear the DTC’s once maintenance has been completed.
How to find the OBD code on a jeep?
When the light goes off, get ready to start counting the light flashings. Once the Check Engine Light has turned off, it will pause in the off position for a second or two, and then start to flash, count the flashes. Each OBD code stored will be given to you in a 2 digit sequence.
What’s the diagnostic code for a Jeep YJ?
Diagnostic trouble code and descriptions: 11*: No crank reference signal detected during cranking. Timing belt skipped one or more teeth; or intermittent loss of either camshaft position sensor or crankshaft position sensor. 12*: Battery or computer recently disconnected within the last 50 start cycles).
Can you check the engine code on a Jeep Wrangler?
When Chrysler / Jeep came up with this idea for getting the engine codes, it was a very smart move. This generation of Wranglers and Cherokees had the most simple diagnostics of any other. You need no special scanner to get the trouble code.
What does open or shorted mean on OBD1 Jeep?
41**: Alternator field control circuit open or shorted. 42*: An open or shorted condition detected in the auto shutdown relay circuit. An open condition detected in the ASD relay output circuit. An open or shorted condition detected in the fuel pump relay control circuit. An open circuit between PCM and fuel gauge sending unit.