What kind of lubricant is in a Jeep transfer case?
Drive Positions and Shift Controls: 2H, 4H, 4L and Neutral. Ranges selected via floor mounted shift lever. 4H and 4L ranges are undifferentiated. Case Configuration: One piece cast iron with aluminum front/rear bearing caps. Lubricant Capacity and Type: 4 pints (1.9 liters) SAE 85W-90 gear lubricant API grade GL-5.
What kind of transfer case does Jeep Wrangler have?
1987-1995 Jeep Wrangler (YJ) w/ NP231 Transfer Case. 1987-2001 Jeep Cherokee (XJ) w/ NP231 or NP242 Transfer Case. 1987-1992 Jeep Comanche (MJ) w/ NP231 Transfer Case.
What kind of case does a jeep NP200 have?
The NP200 was used in the Military WC 61-63. It is a 6×6 Tcase with 3 Outputshafts and a drumbrake on the Straight rear output. It is gear driven and bullet proof. “The NP 207 is one of the weaker Jeep transfer cases, but can be upgraded. The NP 207 has an aluminum case and chain driven planetary reduction.
How does a 4 wheel drive transfer case work?
It is powered by the transmission output shaft and operates much like a secondary transmission. Most 4WD transfer cases have four modes of operation: two-high, neutral, four-low, and four-high. Because the driver only engages the 4WD when needed, this type of system is called “part-time” four-wheel drive.
What kind of transfer case does a jeep have?
This transfer case uses an input gear with 1-3/8″ 6 spline. These vehicles were equipped with the Dana Spicer Model 18 and 20. These transfer cases have a four position shifter that provides two gear ratios in 4WD, one ratio in 2WD, and a neutral position.
It is powered by the transmission output shaft and operates much like a secondary transmission. Most 4WD transfer cases have four modes of operation: two-high, neutral, four-low, and four-high. Because the driver only engages the 4WD when needed, this type of system is called “part-time” four-wheel drive.
How to identify a Dana Spicer transfer case?
Advance Adapters Transfer Case Identification chart for 1941-1979 Jeep Vehicles. The Dana Spicer transfer case, Model MB dual lever shift control, can be identified by the small intermediate gear idler shaft that is only .750″ in diameter.
What’s the difference between Dana 18 and 20 transfer cases?
These exceptions include: the indexing or alignment bearing retainer that protrudes from the back side of the transmission. Another difference is that the Model 20 transfer cases have the power to the rear axle directly in line with the transmission, while the Dana 18 has the power offset to the passenger side.