How does the post doctor fence post repair work?

How does the post doctor fence post repair work?

Fixes 4 x 4 fence and mail box posts without removing fence panels or digging holes All hardware included:nuts, washers, screws, bolts and drill bits Avoid complete post and cement replacement which can cost up to $200 each Fence Post Repair and Mailbox Post Repair The Post Doctor is the #1 fence or mailbox 4 x 4 post repair device on the market.

How to repair a load bearing post ( DIY )?

1 Identify the Problem. 2 Get Expert Advice. 3 Separate Pipes From the Beam and Prepare for Lifting and Shoring. 4 Place the Hydraulic Jack. 5 Set the Jacking Post. 6 Safely Lift the Beam. 7 Dig the Footing. 8 Place the Rebar. 9 Pour the Footing. 10 Place the Pinch Block.

How to find a tradesman to replace a fence post?

Let us help you find a tradesman local to you Most of the time repairing or replacing fence posts is a hugely awkward, difficult job.

Why is it so hard to replace a fence post?

Most of the time repairing or replacing fence posts is a hugely awkward, difficult job. Usually the existing wooden post has rotted at ground level because it has been concreted in by someone who did not take 5 minutes to trowel the top of the concrete to a slight dome allowing the rain water to run off.

Can a post be repaired with post Buddy?

Before you know it, your post will be solid and straight once again. And this is no temporary fix – Post Buddy will give your fence support for years to come. Post Buddy repair stakes are very flexible. This means that after installation, you can easily straighten posts by pulling before you secure them into place.

How to remove a snapped off 4×4 fence post?

Dig a 10 inch diameter hole and set the post 1/3 of its length into the ground [set an 8ft post at least 2 ½ feet deep] so that it is below the frost line. Use a treated 4×4 fence post approved for direct burial and set the post with crushed gravel. Not all fence posts are the same.

Is there a way to mend a broken fence post?

This way the post will not be sitting in cement to rot off again. Before you consider removing the wood post, carefully inspect it for damage.   It could still be salvaged using our fence post mender to repair that cracked or rotted fence post timber in minutes without having to remove any concrete.   Check our products listings for more details.

How to replace a rotted wood foundation post?

Step 1 1 Dig soil away from rotted post. 2 Inspect treated lower board for decay; it may need to be replaced. 3 Brace rotted post by fastening a support beam under truss and lifting with an adequate-sized jack. 4 Make sure brace and jack assembly are installed safely and securely.