How do you remove wire from steering column?
To remove a wire from the connector, use the probe instrument to hold the small tab on the side of the terminal inside the connector and gently slide the terminal out. When installing terminals make sure the crimped side of the terminal is facing the wide side of the connector opening.
Can a bad control arm cause steering wandering?
Another symptom commonly associated with bad or failing control arm assembly is steering wandering. Excessively worn ball joints or bushings can cause the vehicle’s steering alignment to shift, which may cause the steering to pull to the left or right when traveling down the road.
Where is the intermittent wiper control located on a car?
A partial or complete loss of intermittent wiper control. To fix these two problems, you’ll need a shop manual, a digital multimeter and possibly some Torx bits. On most late-model vehicles, the MFS is located under the plastic covers behind the steering wheel.
Is there an ignition kit for a GM steering column?
THE TURN SIGNAL KIT allows the electrical connection of vehicle harness wires to aftermarket, or factory GM steering column with either the 3 7/8 and 4 1/4 11 way turn signal and horn master connector. THE IGNITION KIT adapts the column mounted switch to the vehicle.
Where is the ignition switch on a GM tilt steering column?
The ignition switch bolts to the column with a 5/16″ stud-headed screw. Install the screw finger tight at this time, note the slots that allow the ignition switch to be adjusted up or down the column: We’ll adjust the ignition switch later, after the column is fully assembled. Inside the GM Tilt Steering Column Page 16
What are the safety features of a steering column?
One of the main safety features of the steering column is that this shaft assembly is collapsible.
How is the tilt of the steering column maintained?
The tilt adjustment is maintained by toothed pawls that engage the pins in the top of the lower housing. When the tilt release lever is pulled it releases the pawls and allows the upper column to pivot up and down on the tilt pivot pins.