When to replace a fuse on a jeep?
Look at the silver-colored band inside the fuse. If the band is broken or melted, replace the fuse. Check those fuses first that protect the failed component, but check all the fuses before deciding that a blown fuse is not the cause. Replace any blown fuses with another with the same amperage (same color) and check the component’s operation.
Where are the fuses for the power windows?
You may also have to check the wiring harness that goes into the driver door, hinge side. With the driver door getting the most action, sometimes those wires break. For the power windows, under hood fuse box, fuse #f12 – 50 amp.
Where are the fuses located in a Jeep Liberty?
The electrical power distribution center is located in the engine compartment near the battery. This power center houses plug-in “Cartridge” fuses that replace in-line fusible links.
Why is my power window on my Jeep Compass not working?
Your Jeep Compass’s power window motors can and do fail over time. You’ll have to take the door panel off to get to it. A lot of them are riveted in, so be prepared to deal with that. If you’ve verified that it is getting power with a voltmeter, but it is not working, it’s time to get a new one.
You may also have to check the wiring harness that goes into the driver door, hinge side. With the driver door getting the most action, sometimes those wires break. For the power windows, under hood fuse box, fuse #f12 – 50 amp.
Your Jeep Compass’s power window motors can and do fail over time. You’ll have to take the door panel off to get to it. A lot of them are riveted in, so be prepared to deal with that. If you’ve verified that it is getting power with a voltmeter, but it is not working, it’s time to get a new one.
What is the fuse for the driver door?
With the driver door getting the most action, sometimes those wires break. For the power windows, under hood fuse box, fuse #f12 – 50 amp. Also the TIPM can be out which is common and easy to replace because it self initializes, here are instructions and diagrams for that as well (below).
What to do if front power window does not work?
The following wiring test determines whether or not voltage is continuous through the body harness to the front switch. 1. Remove the power window switch and bezel. 2. Disconnect wire connector from back of power window switch. 3. Switch ignition to the ON position. 4.