Is there a way to override a jeep cooling fan?
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: 9_AtZXZrTRaVu7mI)
What should I do if my fan clutch is on the outs?
Pay attention to changes in air temperature. One of the most common symptoms of a fan clutch on the outs is an inability to properly cool the air circulating through the vehicle. Switch on the A/C and turn it down to the coldest setting.
How many relays are in a Jeep Liberty?
Engine Compartment Fuse Box Diagram № A Protected Component 1 40 Blower Motor Relay 2 30 Radiator Fan (High Speed) Relay, Radiato 2 40 Radiator Fan (High Speed) Relay, Radiato 3 50 Park Lamp Relay, Daytime Running Lamp, H
What causes radial streaks in a fan clutch?
Radial streaks are another potential clue—this happens when oil escapes from the clutch and is then blown outward in all directions by the fan. Inside the fan clutch, there is a small reservoir filled with a viscous silicone-based oil. The oil flows to and from the main chamber as engine heat fluctuates, engaging and disengaging the clutch.
How does the fan clutch work on a Jeep Wrangler?
The fan drive viscous clutch (or fan clutch for short) is a silicon fluid filled coupling with a bimetallic coil that is attached to your Jeep’s fan. When working properly, the fan clutch will react to the heat discharging from you radiator by spinning faster or slower depending on the cooling needs of your engine.
Where is the radiator fan on a Jeep Wrangler?
On a 2000-Up Jeep, the radiator fan is attached to the water pump pulley by a large nut and a fan wrench will be needed to loosen it. 5. The threads on your Jeep’s radiator fan are RIGHT HAND.
What kind of clutch does a Jeep Wrangler have?
The fan drive viscous clutch (or fan clutch for short) is a silicon fluid filled coupling with a bimetallic coil that is attached to your Jeep’s fan.
How to remove the fan shroud on a Jeep Wrangler?
Remove your Jeep’s radiator overflow bottle from the fan shroud and set it aside vertically so that no coolant spills out. 3. Using a 7/16″ socket, remove the 4 bolts securing your Jeep’s radiator fan shroud to the front clip.