Can a CV bearing get stuck in the hub?
The CV joint snout can get stuck in the bearing hub and may need to be pushed outward through the hub. Once the spindle is loose there are two options. Either you can take the unit to an automotive machine shop to replace the bearing or you can press the CV axle bearing out and replace it yourself.
How to remove CV axle seized into hub?
(New Jersey brine and PA salt did a number) I actually pulled the hub apart trying to push it out. Something you might want to try would be adding silikroil to your arsenel. Soak that thing down before you get to far into it like before you start to get all those tools out.
Can a nut be removed from a CV axle?
Once the nut is broken loose you can remove the nut completely. This will expose the lock washer which will still be on the CV axle against the wheel hub. Use a small screwdriver or pick to help remove the washer.
How are CV axles replaced in a car?
CV Axle Bearing Replacement and Spindle Removal. The CV axle is placed through the bearing which rotates allowing the car wheels to turn under the power of the engine. The wheel is bolted to the axle hub which is attached to the end of the CV joint. Once disassembled, this bearing is removed by pressing the bearing from the front or rear spindle.
How do you remove the hub from a CV axle?
Tape the steering knuckle joint with a hammer (hitting the knuckle where the rod goes through and not the threaded portion of the tie rod) to help remove it. Unbolt the hub from the strut tower.
What’s the best way to reinsert a CV axle?
If the axle isn’t quite flush, you can use a rubber mallet to gently tap it into place. Reinsert the axle through the hub assembly. The new axle will have to be reinserted into the center of the hub assembly at the same spot where you removed the old axle.
Can a wheel hub be removed from a strut?
Unbolt the hub from the strut tower. Two more 17mm bolts will connect the wheel hub to the strut tower. Once you remove these bolts, the hub should only be connected by the axle through the center hole, and you should easily be able to remove it.
How to remove a CV nut on a Nissan?
-Now break loose the hub nut using 32mm / 1 1/4″ socket via breaker bar or impact. Note: You may need to bend cotter pin ends down to put a socket on. -Chock rear wheels, jack up truck, place on jack stands, and remove front tire (21mm).