Can you replace a compressor clutch?
it is completely possible to replace only the compressor clutch, but you have to be able to find a replacement. most dealers and parts stores no longer carry individual parts or rebuild kits for compressors any longer. people stopped using them long before their availability started to fade.
How to loosen the clutch on an AC compressor?
5. in picture #1 you can see two long bolts that hold AC compressor, you can use 16mm deep socket with 3/8 drive from the top to loosen top bolt and the same for the bottom bolt but from the bottom side. (you don’t even have to remove the plastic side splash shield and the plastic cooler hose).
How to replace AC compressor clutch in Jeep Cherokee?
(Playback ID: 0OkUpd-zhFEJiqN3) An error occurred while retrieving sharing information. Please try again later.
How do you clutch a gas Jetta compressor?
Remove alternator, remove 2 bolts for compressor then pull the compressor up so that clutch faces towards you, then tie the compressor in that position with a wire or rope. Will this procedure work for a gas Jetta?
What happens when the AC clutch does not work?
An automobile can have numerous serious problems and a dysfunctional AC compressor clutch is one of them. When this component does not work properly, the engine does not get the cold air flow – leading to some major complications. Knowing how to manually engage AC compressor clutch will help you skip a visit to the mechanic.
How do you remove AC compressor clutch?
Insert the male threaded end of the compressor clutch removal tool into the female threaded end of the clutch. Thread the removal tool into the compressor clutch until it becomes too difficult to turn by hand. Tighten it with a standard open-end wrench until it is completely seated.
Can the AC clutch be replaced?
Yes you can just replace the clutch pulley on the a/c compressor. The issue that you may have is the pulley bearing seized up and may have spun on the front of the compressor nose cone and will damage it. You may not be able to get the old pulley off and if you do the new one will not seat and hold on…
Why does my AC clutch not engage?
Why AC clutch won’t engage. If the clutch doesn’t engage, the problem could be a blown fuse, an open in the wire to the clutch coil, a bad clutch coil, a poor ground, or a low pressure lockout. AC compressor clutches receive power in a number of ways.
Can you run car without a compressor clutch?
if the clutch and/or pulley on your compressor are okay, yes, you can continue to operate your vehicle without any issues…without a compressor you will need a bypass pulley and special length of belt.