Why does my Jeep Grand Cherokee fuel Gage stop working?
Jeep Grand Cherokee Questions – fuel gage stops working, then starts working agter time. why is this h… – CarGurus fuel gage stops working, then starts working agter time. why is this happening?
Why is the instrument cluster on my Jeep Cherokee not working?
Checked the fuses, as well as the hot to the cluster from the fuse and back to the battery. Next plan is the grounds and then the connectors. Not liking this instrument panel
Why are the warning lights on my Jeep Cherokee not working?
It is also a probable cause if your Jeep Cherokee warning lights are not working and should be inspected first before concluding that your warning lights need new bulbs. To verify, access the fuse box in the engine compartment under the driver’s side dash, or refer to your owner’s manual for its exact location.
Why is my BCM not working on my Jeep Cherokee?
Should your voltage regulator work just fine, then chances are the issue is caused by a fault with wiring – one of the two causes leading to a fully non-working instrument panel. This fact is especially true for a 2000 Jeep Cherokee, whose wires tend to rub through on the steering column that causes a short with the BCM.
Checked the fuses, as well as the hot to the cluster from the fuse and back to the battery. Next plan is the grounds and then the connectors. Not liking this instrument panel
Why are all the lights on my Jeep Cherokee not working?
The lights work (cel, seatbelt light, air bag, etc) but the actual gauges don’t work. Any ideas of where I should check? All the grounds seem to be connected, and I haven’t made any changes with wiring in regard to the cluster.
Why is the CPS on my Jeep Cherokee not working?
According tothe All Data the white w/ double black trace and the purple with brown trace wires are communication wires that go back to the PCM. Again, another reason why I don’t think that the CPS is bad.
Why is the PCM on my Jeep Cherokee not working?
I did notice that I have a wire (white with double black trace) that is cut, but after pulling the entire harness out I don’t see another end of that wire anywhere. According tothe All Data the white w/ double black trace and the purple with brown trace wires are communication wires that go back to the PCM.