How do you replace the headlights on a Jeep Wrangler?
How to Replace the Headlights on a Jeep Wrangler. Remove the screws that go around the chrome headlight bezel using the Phillips head screwdriver. Once the bezel is unscrewed, the light may fall out of the housing so be prepared. Pull out the headlight using one hand then unplug the back of the bulb from the harness using your other hand.
Where is the high beam headlight on a jeep?
The outer light socket is the low beam headlight, while the inner light socket (toward the grille) is the high beam light bulb. Both the 2006XS and the 2005XS light bulbs are created so that you cannot put either on in the wrong socket. Remove the light bulbs from the sockets. Replace the lights with new bulbs.
How do you remove a headlight from a radiator?
Remove the two bolts that hold the headlight assembly into the radiator core support. These two bolts are on top of the headlight assembly, and can be removed with a 1/4-inch drive ratchet and a socket. Remove the headlight assembly completely and rest it on the front bumper. Remove the light bulb sockets by turning them counterclockwise.
How do you remove a headlight retaining ring?
Sit the bezel off to the side. Loosen the 4 screws that hold the headlight retaining ring into place using a screwdriver. You have two at the top and two at the bottom of the headlight. Remove the retaining ring by simply pulling it away from the headlight.
How do you change a headlight assembly on a car?
Position the assembly so that the bracket tabs are aligned with their slots and slide the headlamp inward to engage the tabs. Replace the two bolts at the top of the assembly. If you’re replacing both assemblies, repeat these steps on the other side.
What’s the best way to remove a headlight?
Refer to a service manual for instructions on removing the bulb, electronics, plugs, and any other components you can. Carefully remove the headlight housing and follow the removal strategy. Use a hairdryer to dry out the moist air without breaking the seal. Use a hairdryer to blow hot, dry air into the vent or on the outside of the headlight unit.
Can you break the seal on a headlight housing?
Breaking the seal between your headlight lens and housing is relatively easy, but once it’s broken, you’ll need to be very cautious to create a firm seal once you replace it. If you aren’t comfortable working with sealants, it might be worth bringing your car to a mechanic who is. Before removing the seal, check your headlight housing vent.
How do you remove a headlamp bracket from a car?
Locate the two bolts on the top of the assembly and remove them with your wrench or socket. Set them some place safe. Now you should be able to gently slide the entire assembly out enough to release the headlamp bracket tabs from their slots on either side.