Where is the ignition switch on a 2005 Jeep Grand Cherokee?
The contact owns a 2005 Jeep Grand Cherokee. While driving various speeds, the vehicle would suddenly shut off. The vehicle was taken to the local dealer (DE cozen Chrysler/Jeep in verona, NJ) where it was diagnosed that the ignition switch was faulty.
When did my Jeep Grand Cherokee ignition fail?
The contact owns a 2008 Jeep Grand Cherokee. While driving 45 mph, the engine seized and shut off. The contact was able to park the vehicle on the side of the road and restart it with no issue. The contact stated she experienced the failure again on July 12, 2019.
What should I do if I need to replace my ignition switch?
Reconnect the cable to the negative (-) terminal on the battery, then insert the key into the ignition and turn it to start the vehicle. The vehicle should start without any issue. If it doesn’t, remove the ignition switch and reinstall it. Shut the engine off (if it starts) and disconnect the battery again.
Are there any problems with the Jeep Grand Cherokee?
Other Common Electrical System related problems of Jeep Grand Cherokee Problem Category Number of Problems Electrical System problems 3956 Alternator/generator/regulator problems 369 Ignition Switch problems 289 Car Will Not Start problems 251
The contact owns a 2005 Jeep Grand Cherokee. While driving various speeds, the vehicle would suddenly shut off. The vehicle was taken to the local dealer (DE cozen Chrysler/Jeep in verona, NJ) where it was diagnosed that the ignition switch was faulty.
The contact owns a 2008 Jeep Grand Cherokee. While driving 45 mph, the engine seized and shut off. The contact was able to park the vehicle on the side of the road and restart it with no issue. The contact stated she experienced the failure again on July 12, 2019.
How do you repair an ignition switch on a jeep?
This Jeep repair is basically in three phases, as you remove the lower dashboard trim, remove the old ignition switch, and install the new ignition switch. Open the hood of the car and secure it. Take your wrench and detach the car battery from the negative cable terminal (black).
What was the problem with my 2008 Jeep Grand Cherokee?
Tl the contact owns a 2008 Jeep Grand Cherokee. While driving, the ignition switch would turn off independently and the vehicle stalled. The vehicle was restarted and was able to drive normally. There were no warning indicators illuminated. The vehicle was not taken to a dealer or an independent mechanic for diagnostic testing.