What to do if you cant push the gas pedal?
Explain your symptoms and have the mechanic drive the vehicle to verify the issue. Once the issue has been fully diagnosed, the mechanic would relay his/her findings over to you to make a repair decision. The statements expressed above are only for informational purposes and should be independently verified.
What kind of golf cart won’t push the pedal?
Yesterday I pulled up to my ball and hit it and then got back into the cart and it wouldn’t go anywhere when I press the pedal I have a 2000 ezgo electric golf cart. I haven’t checked anything I just want to know where to begin . Answered!
What causes no acceleration when pressing the gas pedal?
This may be a result of low transmission fluid or potentially a faulty transmission control module. A faulty transmission control module may cause a delay in acceleration or erratic shifting of gears. The transmission control module has various sensors such… Hi there.
How to change the accelerator pedal release position?
Accelerator Pedal Release Position Learning Procedure. Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.
Explain your symptoms and have the mechanic drive the vehicle to verify the issue. Once the issue has been fully diagnosed, the mechanic would relay his/her findings over to you to make a repair decision. The statements expressed above are only for informational purposes and should be independently verified.
This may be a result of low transmission fluid or potentially a faulty transmission control module. A faulty transmission control module may cause a delay in acceleration or erratic shifting of gears. The transmission control module has various sensors such… Hi there.
How does the ABS work on a Lexus?
The ABS and traction control are part of the same system. The electronic brake control module (EBCM) receives input from the wheel speed sensors, as well as other vehicle sensors. It then uses this information to apply the brakes and…
How to troubleshoot a Mercedes Benz fuel pump problem?
Troubleshooting a bad fuel pump problem on a Mercedes-Benz is easy. This is a job where you need to be extremely careful because you will work near fuel and there is always the risk of fire. It is recommended that you empty the tank or have the fuel tank near empty when you replace the fuel pump.
What should I do if my Mercedes fuel pressure is zero?
If your Mercedes doesn’t start, check the fuel pressure. If you are getting zero reading, you either have an electrical problem or a bad fuel pump. If the check engine light is on, consider yourself “lucky” as it can make your diagnosis easier. Note that not all faults will trigger the check engine light.
How long does a ym240 diesel engine run?
I started my YM240 (24 hp diesel) this spring and it runs absolutely fine for about 1/2 hour – plenty of power under load, no smoke, no blowby, everything seems normal. Then, after about 1/2 hour it starts losing power and in a period of about 3-4 minutes it loses so much power that it can’t climb a small grade unless I drop it into 1st gear.
Why does my car stall at low rpm?
The will likely force your computer to stall the engine and only allow it to run at low RPMs, which means the car will only move at slow speeds. This is a safety feature enforced by the computer so that your engine doesn’t get too damaged.