What should I do if my Jeep Cherokee wont start?
If all powers and grounds check out and we still do not have any reference voltage to the cam, crank or the tps, then disconnect them one by one with the key on to see if the reference voltage comes back. If so, then one of the sensors is bad and will need to be replaced. The TPS reads only .11 VDC.
Why did my 1996 Jeep turn over but not start?
1996 Jeep turns over but will not start. I checked the spark plugs and there is no spark. Changed rotor, distributor Jeep Cherokee: 1996 Jeep turns over but will not start.
Why is my Jeep Cherokee not waking up?
If there is no reference voltage to these sensors with the key on, then the computer might not be waking up. We will need to check all powers and grounds going into the computer with the key on.
What to do if your Jeep turns over?
Put the black lead of your meter on battery ground and the red lead of your meter on one wire at a time going to the ignition coil while someone is cranking the engine over and take a reading. Experience: ASE certified Technician advanced level specialist. Wisconsin certified emissions state inspector I will let you know soon.
How can I tell if my Jeep Grand Cherokee is shifting?
Turn ignition key ON and OFF three times, finally leaving the key in the ON position. Leave the Overdrive Off Switch in the normal overdrive (ON) position. Immediately begin counting the number of flashes displayed by the Overdrive Off Switch indicator lamp. There will be two sets of flashes, separated by a pause.
Is there a problem with my Jeep Grand Cherokee?
Very often, this will solve the problem. But Jeep Grand Cherokees seem especially prone to more serious transmission problems, and some owners are quite vexed at their inability to determine the causes.
Why does my Jeep Cherokee stall while driving?
A significant number of drivers have reported that not only did their Jeep Cherokees lose engine power while driving, but in nearly all cases, stalling occurred without any warning and with no indicator lights on the instrument panel.
What’s the Flash code on my Jeep Grand Cherokee?
Code 26 – Governor Pressure Sensor Offset Drift Code 55 – End of Message You may or may not be skilled enough to actually fix the problems indicated by the flash codes yourself, but you’re better-armed with an understanding of where the issues lay as you seek help from a mechanic.