How much is a water pump for a 1997 Jeep Wrangler?
The average cost for a Jeep Wrangler water pump replacement is between $362 and $399. Labor costs are estimated between $142 and $179 while parts are priced at $220.
What should I do if my Jeep Wrangler is hot?
What this test will confirm is if the head gasket is letting engine compression into the cooling system (radiator) or not. Now, if the engine in your Jeep 4.0L Cherokee (or Grand Cherokee, Wrangler) has been running for a while and it’s hot, let it cool down for about an hour, since a radiator cap should never be removed with the engine hot.
What happens if you blow the head gasket on a Jeep Wrangler?
In some occasions, the head gasket will get burned between two cylinders, causing a gap that will let the compression/ combustion of one cylinder to leak into the other and vice-versa. If this happens, in a Jeep 4.0L Cherokee (or Grand Cherokee, Wrangler), this will cause a No Start Condition.
Can a jeep 4.0L Grand Cherokee not start?
If your Jeep 4.0L Cherokee (or Grand Cherokee, Wrangler) doesn’t start, well this will not be an issue since the coolant will be cold. Alright, this is what you need to do:
When to take radiator cap off Jeep Wrangler?
Now, if the engine in your Jeep 4.0L Cherokee (or Grand Cherokee, Wrangler) has been running for a while and it’s hot, let it cool down for about an hour, since a radiator cap should never be removed with the engine hot. Please take all necessary safety precautions.
How much does it cost to replace a water pump in a Jeep Wrangler?
The average cost for a Jeep Wrangler water pump replacement is between $247 and $318. Labor costs are estimated between $132 and $167 while parts are priced between $115 and $151. Estimate does not include taxes and fees.
Why is my water pump not working on my Wrangler?
A failed water pump can be caused by other problems in the cooling system, such as a bad thermostat, radiator or head gasket. Can I drive with a water pump problem? If the water pump is not maintaining good coolant circulation, the engine will overheat, causing leaks, possible head gasket damage and ultimately a failed motor.
Why is my oil pressure so low on my Jeep Wrangler?
I would first check the oil level but if it’s idling fine with no drivabilty or audible issues, the likely culprit is the ever so common oil sending unit failure, easily replaced. Usually found on the passenger side block near the oil filter.
Where does the gauge needle go on a Jeep Wrangler?
The cluster is programmed to move the gauge needle back to the low end of the scale after the ignition switch is turned to the Off position. The instrument cluster circuitry controls the gauge needle position and pro- vides the following features: