What happens when there is no power to the fuel pump?
If only the left signal is not working, suspect a faulty bulb. If a replacement bulb does not fix the problem then the circuit is lacking either power or ground. In this case, electrical diagnosis will need to be performed…. How do I calculate the fuel economy?
What causes water to leak out of a water pump?
Many water pumps have a weep hole in front of the seal that will allow water to leak out if the seal is bad.
How can you tell if your water pump is going bad?
Start your car’s engine with the hood up. If you hear a low-pitched grinding noise, it may indicate that your water pump bearing is going bad. You can often hear it plainly if it’s gone bad.
Why does my fuel pump feel like it is surging?
Irregular resistance inside the fuel pump motor may cause vehicle surging, and indicates a fuel pump in need of repair. Surging feels like the gas pedal has been used. However, it occurs at a random, consistent speed.
Why is there no oil in my Jeep Liberty?
There is a tube in your Liberty that takes the oil from the pan to the oil pump. This is called the pickup tube. This tube can fall out, which will cause no oil to get to the oil pump. Modern engines use a bypass valves to keep oil flowing to the engine even when the filter is clogged.
Why does my Jeep Wrangler not accelerate when I push the gas?
If your Jeep Wrangler won’t accelerate, that is a serious cause for concern. There are a lot of different reasons that can cause this. Diagnosing the issue can be narrowed down by whether the engine is still revving when you push the gas or not. There is a section for each scenario with likely causes for each.
What to do if your liberty has low oil pressure?
As stated above, checking the oil level in your Liberty is definitely the place to start diagnosing low oil pressure. If the oil level is really low, you’ll need to fill it up until it’s back to the full mark. This may solve the problem. Keep in mind that if the oil has leaked out once, it will leak out again.
Why does my Jeep Wrangler not turn the wheels?
If you’ve broken a drive/axle shaft, your Jeep Wrangler’s transmission has no way to turn the wheels anymore. If this were the case, there would not be any movement whatsoever from the vehicle. You also wouldn’t feel the slight jerk your Wrangler as you put it into gear.