How do I make my dash lights brighter on my Jeep Wrangler?
Rotate the center portion of the lever up to increase the brightness of the instrument panel lights when the parking lights or headlights are on. Rotate the center portion of the lever upward to the next detent position to brighten the odometer and radio when the parking lights or headlights are on.
How to repair the fuel gauge on a Jeep Wrangler?
Pull the relay panel lid off. Pull out the old fuel sensor relay. If you are unsure of its location, consult the relay diagram on the inside of the relay panel’s lid. Plug the new sensor in and replace the relay panel lid. Replace your Jeep’s negative battery cable. “Haynes Jeep Wrangler 1987-2003 (Haynes Manuals) “; Mike Stubblefield; 2005
Why are all the Jeep CJ gauges dampened?
The dampening mechanism is basically some thick grease on the movement’s pivot points. The reason all the meters are dampened is because the senders do not have a very constant resistance. If you put a good testing meter on the sender while the motor is running you will see the resistance bounce all over the place.
What kind of temperature gauge does a jeep have?
The type in the Jeep is a NTC (Negative Temperature Coefficient) which means that as the temperature goes up, the resistance goes down. From the passenger side which is left to right in the picture above. Temperature Gauge A Terminal – Jumper from fuel gauge A terminal (Jumper Strap regulated to 5v)
What are the gear ratios on a jeep 904?
904: A light duty 3 speed automatic used in CJs from 1980-1986 only with the I4 engine. It was also used during this time period with XJs and MJs with the I4 and V6 engine. Gear Ratios: 1st Gear: 2.74:1, 2nd Gear: 1.54:1, 3rd Gear: 1.00:1, Reverse Gear: 2.03:1
Why are the gauges on my Jeep YJ not working?
It is not that uncommon for Jeep Wrangler YJ dash gauges to go out and the fix can be fairly easy…. if you can find the problem. I show the steps I went through on how to fix the gauges on my 1994 Jeep wrangler YJ. 2: Cleaning the ground wires on the engine. 3: Removing the instrument cluster to check the connection of the gauges.
904: A light duty 3 speed automatic used in CJs from 1980-1986 only with the I4 engine. It was also used during this time period with XJs and MJs with the I4 and V6 engine. Gear Ratios: 1st Gear: 2.74:1, 2nd Gear: 1.54:1, 3rd Gear: 1.00:1, Reverse Gear: 2.03:1
What to do if your dash light does not work?
#Test the dashboard light bulbs. If the fuses are working properly, check for a blown bulb in the dashboard. Following the manufacturer’s instructions, disconnect the battery while working on the dash, remove the faceplate covering your vehicle’s dashboard gauge panel. Remove the screws holding the plate on. Carefully remove the faceplate.
What kind of transmission does a Jeep Wrangler have?
Jeep Automatic Transmission Guide. A summary of the automatic transmissions used in various Jeep vehicles. 42RLE: Four-speed automatic transmission was available from 2003 to 2006 Jeep TJ Wrangler with 4.0L engines. 45RFE: A four speed automatic transmission was used in 1999 Jeep Grand Cherokees with 4.7L engines.