What does code U0141 mean?
The U0141 OBD-II diagnostic trouble code (DTC) on Your Dodge means “Lost Communication With Instrument Panel Module” — which, as You’re aware, is the thing with Your gauges and other displays!
How to fix no bus on a Jeep Wrangler?
How to fix noBus on a Jeep Wrangler. You’ll need a small and big 4 way screw driver, something to pry with (pocket knife, straight screwdriver) rubbing alcohol and cotton swaps. Category Autos & Vehicles Show moreShow less Loading… AutoplayWhen autoplay is enabled, a suggested video will automatically play next. Up next
Is there a problem with my YJ Wrangler?
A common problem with YJ Wranglers – turn the key and it doesnt start or it takes a few minuted to fire up Sometimes called “Lazy PCM”. Some simple tips and a certain way to tell if it is you ECM going south. I discuss “Forums” and a redneck tool from the Redneck Garage
Why is my Jeep PCM not working properly?
If the problem was only with the scanner connection, the jeep would at least run normally. Now these 2 problems combined would lead to think that there is some electrical connection problem with the PCM. I would disconnect the battery and then disconnect and clean the PCM connectors with electrical contact cleaner.
How to take ECU out of Jeep Wrangler?
1. take ECU out of Jeep you’ll need to remove the washer fluid container held on by one philips screw on the side and then it just slides right out. 2.now for taking off the ECU disconnect the main wiring harness leading into it using a 8mm socket, when loosen bolt and pull off gently being sure not so break any contacts.
How to fix noBus on a Jeep Wrangler. You’ll need a small and big 4 way screw driver, something to pry with (pocket knife, straight screwdriver) rubbing alcohol and cotton swaps. Category Autos & Vehicles Show moreShow less Loading… AutoplayWhen autoplay is enabled, a suggested video will automatically play next. Up next
How to reset your Jeep engine control module?
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.
Why is the OBDII connector on my Jeep not working?
Went to get my Jeep inspected yesterday, and they came back in to the office and said, “We can’t do the inspection because the OBDII connector isn’t working.” The report from the inspection computer said “NOT CONNECTED”. I need to figure out what exactly to check, I know my way around OBDII vehicles, but can’t seem to find what powers the OBD port.
What happens if I Reset my Jeep ECM?
To finish off this post , here are a couple of things you should keep in mind. Resetting your Jeep ECM will not have any effect on your vehicle’s mileage, Resetting it should not cause any issues between your other module so feel free to this as many time as you want if you’re trying to diagnose a problem with your car. For good measure.