What to put on front crankshaft seal on Jeep Wrangler?
You will need the metal sleeve, it slides on your crank end and provides a new surface for the seal to seat on. If you feel your crank end surface there will probably be some variations due to seal wear. There should be a sealant in the kit to install the sleeve.
Where is the front crankshaft seal located on a car?
At the front of the engine there is a seal that designed to control oil from leaking out. This seal is located at the front of the crankshaft as it protrudes out of the front of the engine block. The front part of the crankshaft is where the balancer or dampener (same thing) is bolted too and is where the serpentine belt is driven from.
Why does the bottom bracket stay on a Jeep Wrangler?
The bottoms can stay on because the radiator bottom bracket has slots at the bottom of the bolt holes so you can just lift it out after removing the top ones and just loosening the bottoms. Once the radiator is out there is a lot more room.
Where are the a / C lines on a Jeep Wrangler?
After removing the 4 bolts (2 on top and 2 on bottom) I opened up the hold-down clamps for the metal A/C lines coming down the passenger side inner fender. This allowed enough “play” that I was able to lift the condenser up a bit and prop it up temporarily with a block of wood.
Is there a crankshaft sensor for a Jeep Cherokee?
Your Jeep Cherokee will be happy to know that the search for the right Crankshaft Position Sensor products you’ve been looking for is over! Advance Auto Parts has 38 different Crankshaft Position Sensor for your vehicle, ready for shipping or in-store pick up.
You will need the metal sleeve, it slides on your crank end and provides a new surface for the seal to seat on. If you feel your crank end surface there will probably be some variations due to seal wear. There should be a sealant in the kit to install the sleeve.
What kind of bolts are in a Jeep Cherokee?
27.12 XJ – Brake Pedel Pivot Pin Nut Type: 7.5 10.17 XJ – REAR Wheel Cylinder Mounting Bolts Type: Bolt 40.67 XJ – FRONT Caliper Mounting (Guide) Pins Type: Bolt 104.4 XJ – FRONT Caliper Achor Plate Bolts Type: Bolt 40.67 XJ – REAR Crossmember to Chassis Sill Bolts Type: Bolt
What are the torque specifications of a Jeep Cherokee?
31.18 XJ – FRONT Brake Hose to Caliper Inlet Fitting Bolt Type: Bolt 27.12 XJ – Brake Pedel Pivot Pin Nut