What should the voltage be on a Jeep Compass?
Set it to read voltage. Specifically, you’ll need to set it to 20V DC. With your Compass turned off, you’ll connect the negative side of the meter to the negative battery post or wire. You’ll then touch the positive side of the voltmeter to the positive battery wire.
When did the Jeep Commander XK come out?
The mid-size SUV Jeep Commander (XK) was produced from 2006 to 2010. In this article, you will find fuse box diagrams of Jeep Commander 2006, 2007, 2008, 2009 and 2010, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
What happens if you have a bad alternator on a Jeep Compass?
As described above, a bad alternator will drain your Compass’s battery fast. When the battery gets so dead it will no longer be able to power your Compass’s ignition system. As the ignition system is no longer able to produce a full powered spark, the engine will begin to sputter and stall.
Where is the fuse panel on a Jeep Commander?
The fuse panel is located under the instrument panel just to the left of the steering column near the brake pedal (behind the cover near the OBD). Mem. Sw, Courtesy Lamp (B+) Final Drive Control Module (FDCM), Heater Ventilation, Air Conditioning (HVAC), Switch Bank.
How many Jeep Commander radios are left in stock?
Only 11 left in stock – order soon. . Only 19 left in stock – order soon. . Only 11 left in stock – order soon. . Only 9 left in stock – order soon. . . Only 4 left in stock – order soon.
The mid-size SUV Jeep Commander (XK) was produced from 2006 to 2010. In this article, you will find fuse box diagrams of Jeep Commander 2006, 2007, 2008, 2009 and 2010, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
The fuse panel is located under the instrument panel just to the left of the steering column near the brake pedal (behind the cover near the OBD). Mem. Sw, Courtesy Lamp (B+) Final Drive Control Module (FDCM), Heater Ventilation, Air Conditioning (HVAC), Switch Bank.