How do you replace a battery on a Rubicon 500?
Replace the battery with a 14-BS type battery and apply dielectrical grease generously to the positive and negative terminals. Reconnect the positive terminal first, then the negative terminal, and replace the battery holder band. Reinstall the seat by lining the prongs on the front of the seat up with the retainers on the Rubicon 500 frame.
How do you change the battery in a Jeep Wrangler?
Replacing the battery in your Wrangler involves removing the terminals. When you reconnect the terminals, your radio presets are likely to be cleared out. In some Wranglers, you may need to re-enter a security code to get your radio to work again.
Why is my Honda Rubicon 500 not starting?
The Rubicon 500 is a rugged, all-terrain vehicle with a 499 cc engine, manufactured by Honda. If you haven’t ridden your Rubicon 500 for an extended period and you are having trouble starting the engine, the battery may be the culprit. Honda makes it easy to access and replace the battery in the Rubicon 500.
What kind of engine does a Honda Rubicon have?
The Rubicon 500 is a rugged, all-terrain vehicle with a 499 cc engine, manufactured by Honda. If you haven’t ridden your Rubicon 500 for an extended period and you are having trouble starting the engine, the battery may be the culprit.
Replacing the battery in your Wrangler involves removing the terminals. When you reconnect the terminals, your radio presets are likely to be cleared out. In some Wranglers, you may need to re-enter a security code to get your radio to work again.
Can you replace the PCM on a 2007 Jeep Liberty?
When you’re searching for a replacement PCM, it’s important to keep in mind that PCMs are programmed for a specific make and model of vehicle. If you drive a 2007 Jeep Liberty with a 3.7-liter V6, you can’t use just any PCM. You can’t use just any Jeep PCM replacement.
What to do if your backup camera is broken in your Jeep?
Open the hood and disconnect the positive battery terminal. Touch it to a ground (electrical, not the physical ground) for 30 seconds. This will discharge the capacitors that are keeping the memory working in your Jeep. Reconnect the battery cable.
How big of a cable do you need for a Jeep Wrangler battery?
Next, move on to tighten down the two nuts that hold the brass down onto the terminals. The positive side is 9/16-inch, but you can use a 14mm. The negative side is ½-inch, or 13mm. They’re actually standard fasteners, but these metric sizes are close enough to to work. The factory cable ends go under the next ⅜-inch bolt down the rail.