How do you get air out of clutch pedal?
I finally found a reference that mentions having to remove the master cylinder and hold it (piston pointed down) for 10 seconds to get out air that is trapped when the clutch master cylinder is in the standard mounted position. So I could bleed it for days with the bleeder screw and probably never get all of the air out.
What causes a petal to fall out of the clutch?
Check linkage. sometime the rod that pushes the t/o rod fork will fall out of the rod. It’s not attached, held in place only by spring pressure. Easy fix if that’s the case, caused by out of adjustment. Good luck , hope that’s all it is. Worst case all pressure plate componets destroyed and nothing to give petal something to push
Why do I have no pressure on my Clutch?
If there is no pressure at all, most likely the throw-out bearing fork rod or the linkage to it broke. If a pressure plate is worn, or t/o bearing bad, flywheel scorched, all that you would sttill feel pressure on the petal.
What did I do when my Clutch did not work?
So, the long story short, my clutch did not work at all. I went to Pick and Pull, picked up a separate small clutch reservoir from some older car for $2, installed it nearby the brake/clutch reservoir of my car and corked the existing clutch fluid outlet.
I finally found a reference that mentions having to remove the master cylinder and hold it (piston pointed down) for 10 seconds to get out air that is trapped when the clutch master cylinder is in the standard mounted position. So I could bleed it for days with the bleeder screw and probably never get all of the air out.
Check linkage. sometime the rod that pushes the t/o rod fork will fall out of the rod. It’s not attached, held in place only by spring pressure. Easy fix if that’s the case, caused by out of adjustment. Good luck , hope that’s all it is. Worst case all pressure plate componets destroyed and nothing to give petal something to push
So, the long story short, my clutch did not work at all. I went to Pick and Pull, picked up a separate small clutch reservoir from some older car for $2, installed it nearby the brake/clutch reservoir of my car and corked the existing clutch fluid outlet.
If there is no pressure at all, most likely the throw-out bearing fork rod or the linkage to it broke. If a pressure plate is worn, or t/o bearing bad, flywheel scorched, all that you would sttill feel pressure on the petal.