How do you install a boss snow plow?
Begin the assembly procedure by cutting down each corner of the plow box so that each wall of the box will lie flat on the floor. The box can be used as a mat and will help prevent scratching the blade during installation. 2. Place Plow Blade (4) face down on the box. 3. Install MSC01570 Cast Shoe Assembly (12).
How does a 10’V blade plow work?
Assembly (1) using Note:The 10’ V-Blade plow uses a 5/16” x 2” Bolt and a 5/16” Locknut in place of 3/16” Cotter Pin (100C). connect the loose end to the rear Hydraulic Fitting 19. Tighten the four Trip Springs (18) on Push Frame (3) until there is a 1/32” space between each spring coil.
How do you lower the kickstand on a snow plow?
• Lower the plow. Pull the kickstand spring pin to release and lower the kickstand. • Turn the SmartHitch switch to the top position, and press the raise button on the in cab control until the coupler moves toward the truck and releases tension on the spring pins. • Pull the coupler spring pins outward and rotate to the opened position.
What to do when your snowplow blade swings back?
Before tightening the hardware, it is advised that you extend Shock Absorber (10A) to reveal approximately 1/4” of the rod. This will prevent Shock Absorber (10A) from bottoming out when the blade swings back after tripping. Keeping the shock extended, fully tighten Hex Head Cap Screws (96) and Nylon Lock Nuts (109). 11.
How do you wire a snow plow light?
With your 88 its’ dead easy to wire the plow lights to work in conjunction with your regular headlights by simply putting a double pole double throw switch in the circuit. There is nothing fancy about the system and, in this case, I think a switch is simpler and more reliable than a relay.
Can a snow plow be run with headlamps on?
Even if the truck headlamps are on when plowing,it will not hurt anything,unless you tie your plow lamps into them,and they are all on at the same time. Your plow lights will be powered seperately,fed from the battery,and only triggered by the running lights,or a switch.
How tall is a straight blade snow plow?
Engineered for strength and weight, this plow is ideal for personal and light commercial applications such as driveways, small commercial lots and parking spaces. The reliable 14-gauge powder coated steel moldboard is 27″ tall and 7′ 6″ wide for rugged snow plowing performance without the extra weight.
What are the pins on a plow light?
Pins 87 and 87a simplified: Pin 87 will have power when the plow light switch is on 87a will have power when it is off. I have a diagram here somewhere if you want to do a headlight wiring upgrade too that will take pretty much all the load off of the factory headlight switch.