What should the Ohm reading be on a fuel injector?
Connect the voltmeter leads to the terminals, the polarity of the leads is irrelevant. This test gives a baseline ohm reading of all injectors, a service manual also has this information. Most injector readings should range between 11 and 24 ohms.
How are the wires connected to a fuel injector?
Each fuel injector will have a metal clip plugged into it with two wires coming out of it. One of those two wires is a 12-volt constant that should be continuously receiving power from your vehicle’s electrical system. There should be a small portion of each wire exposed coming out of the plastic clip that connects to the injector.
What should the ground voltage be on an injector?
One will be connected to ground and will read 0 volts. The other should read around 12 volts. Step 5: Repeat with all injector wiring harnesses. Leave the ground lead in position and test all of your injector wiring harnesses. They should all be around 12 volts. A lower reading means there is excess resistance in the wire somewhere.
How do you test a fuel injector circuit?
Injector Circuit Power Test With the key in the on position use a test light or voltmeter connected to the negative side of the battery. Gently probe both sides of the injector wiring connector, one of the wires should react by registering around 12 volts on the meter or illuminating the test light.
How to troubleshoot a bad fuel injector in a Jeep Wrangler?
TIP 1: The engine in your 4.0L Jeep Cherokee (Grand Cherokee, Wrangler) needs to be at operating temperature to get an accurate snapshot of the condition of the fuel injectors. TIP 2: If your Jeep doesn’t start, you don’t have to worry about performing the test with a warmed up engine.
How to test the fuel injector Plug Plug?
1 Turn the multimeter to “Ohms.” 2 Place the multimeter leads into the fuel injector plug terminal. 3 Read the Ohms, or resistance, produced by the fuel injector. Note the value or write it down. 4 Test all the fuel injector Ohm readings. Compare the value of each reading to the other values.
What should the resistance of a fuel injector be?
They will range from 12 to 17 ohms. Low impedance injectors are found on high performance and larger injectors. They have much lower resistance, typically around 2-5 ohms. Step 5: Repeat with all injectors. They should all have a resistance within half of an ohm from each other.
Can a failed fuel injector have the same ohm value?
Operational fuel injectors will have the same, or very similar, Ohm values. A failed injector will have too little or too much resistance and the Ohm value will be widely different than the other readings. Replace the injector if the Ohm value is significantly different than other injectors.