What size are drive shaft bolts?
They are 8mm. I have used a 5/16 on them, but the 8mm fits tighter. Use a 6 point 8mm socket. If you are using a 12 point old stylee socket it might not be a great fit on something so small.
Should my front drive shaft spin in 2wd?
No, your front driveshaft will not spin freely in 2wd. Your front axle and driveshaft are always locked and spinning when your vehicle is moving.
How tight should AU joint be?
a U-Joint is a bearing, so any resistance or pinch and you’re asking for premature wear… on the tight side of the cross… on the body of the joint, not the cap, use a flat-nosed punch and give it a sharp “rap” this will slightly move the cap outward against the clip… not too far or you’ll put too much strain on …
Where are the bolts on the front drive shaft?
Enter your ride HERE to be a part of this month’s Ride of the Month Challenge! This is a heads up for those that haven’t ran into this issue yet. I had to replace the u joint in the front drive shaft. The Torx head bolts on the front side of the drive shaft are a pain to get off.
What should the torque be on a Mercedes drive shaft?
Tighten the bolts on a cross pattern to the specification. The typical torque specification is 40 Nm, but you should verify this value by calling the dealer. Once you are done installing all the bolts, give them a 90-degree turn to finish the installation.
What kind of wrench do I need for front drive shaft?
If the grade of bolt is the same, and you can fit a proper wrench/ socket in there, you should be golden. Pull the T-Case side of the shaft first. Makes life WORLDS easier. Then just make sure your torx bit is in and make sure you pull straight on your ratchet.
How to support a two piece driveshaft in a Dodge Ram?
For a two-piece driveshaft, also support the center. Attach the slip yoke to the transmission (or transfer case). Install the center bearing (carrier bearing) support bracket. Then bolt in the rear U-joint or four-bolt flange on the truck’s differential pinion.
Enter your ride HERE to be a part of this month’s Ride of the Month Challenge! This is a heads up for those that haven’t ran into this issue yet. I had to replace the u joint in the front drive shaft. The Torx head bolts on the front side of the drive shaft are a pain to get off.
What’s the best way to install a drive shaft?
Use a pair of cheap nitrile gloves to prevent any dirt on your hands getting on them. Align the zerk fittings on the new u-joints so that when you have to grease them you don’t need to move the truck. Installing the drive shaft is the reverse of removing it, you’ll want to start with the transmission side first.
If the grade of bolt is the same, and you can fit a proper wrench/ socket in there, you should be golden. Pull the T-Case side of the shaft first. Makes life WORLDS easier. Then just make sure your torx bit is in and make sure you pull straight on your ratchet.
When do you need to replace the drive shaft?
The drive shaft is what delivers power from the transmission to your wheels. A u-joint is found on both ends of the drive shaft, this is what allows the drive shaft to spin. Overtime, the u-joints wear out and will begin to squeak, this is when they need to replaced.