How do you change a bulb in a cluster?
Next remove the instrument cluster bezel (plastic window) to access the cluster retaining screws. Tilt the cluster forward and disconnect the electrical connectors (Photo 2). Remove the cluster, turn it over and locate the bulb sockets. Remove the old bulbs and insert the new ones (Photo 3).
Where are the center console lights on a jeep?
On the right hand side of the left temperature gauge it fades and on the left hand side of the right gauge it fades as well…it looks like a light is dim / out smack dab in the middle. Also, on top of the row of lights where the information center button is, the STEP button is out but the others are lit up.
What should I do if my dashboard light is not working?
Use a screwdriver to remove the screws holding each piece of trim in place, then pull the trim away from the dash. On some vehicles, you may have to remove the radio to access the trim. Be sure to keep track of all the screws and set them aside in a safe place so you can replace them when you’re done.
What to do if your light switch wont work?
If adjusting the switch doesn’t work, you may have a blown fuse or bad lightbulb. Or, the entire switch may be faulty, in which case, have it replaced by a certified mechanic. Turn off your headlights and vehicle when you’re done.
How do you change the light bulb on a Jeep Grand Cherokee?
Locate the bulbs that you need to change on the rear of the cluster. Turn the bulb holder counterclockwise to remove the bulb holder and bulb from the cluster. Insert the new bulb and reinstall the holder, turning it clockwise until it locks in.
Where are the warning lights on a Jeep Grand Cherokee?
There are several other bulbs involved in illumination of the warning lights as well in the cluster. To access any of these lights you will have to remove the cluster from the dashboard to remove the bulbs from the back side. The procedure for removing the cluster is really not as bad as you may think.
Why is my brake light not working on my Jeep Grand Cherokee?
Jeep Grand Cherokee brake light not working – fixed! – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
How do you change the bulb in a cluster?
Locate the bulbs that you need to change on the rear of the cluster. Turn the bulb holder counterclockwise to remove the bulb holder and bulb from the cluster. Insert the new bulb and reinstall the holder, turning it clockwise until it locks in. Slide the cluster back into the dash and plug in the electrical connector.