How to remove a 1996 Chevy truck power steering pump?

Open the hood and disconnect the ground battery cable using a wrench. This is the black cable connected to the battery post with the negative or minus (-) sign next to it. Rotate counterclockwise the belt tensioner arm using a 3/8-inch drive ratchet and slip the belt off the power-steering pump pulley.

How do you replace a power steering pulley?

The special puller consists of a split-ring flanged adapter, a ring, a puller bolt, and a puller nut with a flange. Slide the smooth end of the puller bolt into the hole in the pump shaft, and run the nut down to the pulley. Then place the two-piece adapter into the pulley groove and over the puller nut flange.

What to do if your power steering pump is not working?

If the serpentine belt does not hold the fan pulley from turning, try pressing on the belt while striking the wrench with a hammer. If it requires so much force that you turn the crankshaft, you will need to remove the serpentine belt (see steps 6-7) and hold the pulley with a strap wrench. Holding the fan blades won’t work.

How does a GM steering system kit work?

Due to inconsistent steering feel, GM introduced a kit (19168825) to remove the EVO component from the system. The kit has an adapter and union that allows the existing high pressure hose to be connected to the back of the pump after the EVO unit was removed. The GM kit allows the pump to function as a normal steering system would. This

How much does it cost to fix a GMC Yukon power steering pump?

Know what price you should pay to get your vehicle fixed. The average cost for a GMC Yukon power steering pump replacement is between $267 and $659. Labor costs are estimated between $161 and $204 while parts are priced between $106 and $455.

How do you replace a power steering pump?

To replace the pump, the power steering fluid will first need to be drained. The serpentine or power steering belt will be removed, the hoses will be taken off, and the pump will be unbolted from the engine block. A new pump will then be installed, the lines attached, the belt reinstalled, and the fluid refilled.

How do you replace power steering in a Chevy Silverado?

Reconnect the negative (black) battery terminal. Use a funnel to direct the power steering fluid into the pump, and pour until the fluid reaches the fill line. To make sure the power steering fluid is circulating throughout the entire system, turn on the engine and rotate the steering wheel left as well as right multiple times.

Where is the oil catch on a power steering pump?

There are two hydraulic power steering lines connected to the pump: a supply line and soft return line. Place an oil catch pan directly underneath the power steering pump. Use an adjustable wrench to loosen the nut on the supply line, and remove the line to let the fluid drain into the pan.

Which is performance tool for GM power steering pump?

The Performance Tool W87022 Gm Power Steering Pump Pulley removes and installs GM power steering pump pulleys, exerts force only through the shaft to prevent damage to pump and pulley.

When do you need to replace a power steering pump?

When the reservoir on the power-steering pump cracks, the pump shaft seal begins to leak, the fitting O-rings on the stud or bolt leak or an internal component fails, you need to remove and replace the pump. If possible, take the old pump with you to the auto-parts store and make sure you have the correct replacement for your particular vehicle.

What kind of power steering pump pulley do I Need?

Removes and installs pulleys on the following: 1990 – Current Chevy Lumina APV, 1990 – Current Oldsmobile Silhouette, 1990 – Current Pontiac Trans Sport, 1991 – Current Buick Regal with 3.1L V-6, 1991 – Current Chevy Lumina with 3.1L V-6, 1991 – Current Pontiac Grand Prix with 3.1L V-6 In Stock. FREE Shipping on orders over $25.00. Details

Navigation