Where is the starter on a 2012 Jeep Liberty?
As the owner of a 2012 Jeep Liberty, You may be in the situation of needing to locate the starter in Your engine for an inspection. You can find the starter for this make and model on the driver’s side of the engine’s mount, beneath the left cylinder bank.
Why does my Jeep Liberty turn over but not start?
When attempting to start the engine, it turns over normally but will not start. The engine does not even attempt to start. Found the problem, a mouse had chewed through a wire located near the ECU. The ECU is located on the fender by the right side hood hinge.
Where is the ECU on a Jeep Liberty?
The ECU is located on the fender by the right side hood hinge. Spliced the wire and wallah it starts and runs normally!!!! Jeep will start and run fine, then once in a while when turning off it won’t strt. Engine cranks, but won’t actually start. Leave it sit for half hour or so and it will start right up!
What was the problem with my 06 Liberty?
My 06 liberty was running fine it seemed ! It been running 30 minutes with no problem.it sat idling while i put the fam in the car,and we started driving.about a half mile away i came to a stop sign,when i went to take off,it choked bad but then it caugh n was still running and i went ! 2 blocks later ? It stalled !
What to do if your Jeep won’t start?
Jeep will start and run fine, then once in a while when turning off it won’t strt. Engine cranks, but won’t actually start. Leave it sit for half hour or so and it will start right up!
When attempting to start the engine, it turns over normally but will not start. The engine does not even attempt to start. Found the problem, a mouse had chewed through a wire located near the ECU. The ECU is located on the fender by the right side hood hinge.
When did my 2012 Jeep Liberty not start?
I have a 2012 Jeep Liberty and this started close to 2 years ago now. Randomly would not start every once in a while (it would crank but not start). Went to goodyear, they replaced my throttle body, did a bunch of other work (close to $1,000) and then 6 months later it started again.
The ECU is located on the fender by the right side hood hinge. Spliced the wire and wallah it starts and runs normally!!!! Jeep will start and run fine, then once in a while when turning off it won’t strt. Engine cranks, but won’t actually start. Leave it sit for half hour or so and it will start right up!
Jeep will start and run fine, then once in a while when turning off it won’t strt. Engine cranks, but won’t actually start. Leave it sit for half hour or so and it will start right up!