How to replace the serpintyne belt on a Jeep Cherokee?
Using a 12 point, 17mm socket and a long handle ratchet (3/8″ drive), rotate accessory drive belt tensioner (5) counterclockwise until it contacts its stop. 20. Remove accessory drive belt (3). 21. Slowly rotate the belt tensioner (5) back into it’s freearm position. Was this answer helpful? I have a 2005 Jeep Cherokee 2.8 Ltr Diesel.
How to tell if your serpentine belt needs to be replaced?
Look for signs of damage or wear on the belt. Once you have located the serpentine belt, inspect it visually for signs of damage. If the belt is frayed, coming apart, or has marks that indicate that it has been rubbing on something, it will need to be replaced.
What kind of pulley does a serpentine belt use?
Determine if there is a belt tensioner pulley. Depending on the application, your serpentine belt will either have tension placed on it using a movable bracket or an auto tensioner pulley. This pulley uses an internal spring to apply consistent pressure to the belt at all times.
Where do I find the serpentine belt routing diagram?
Find the serpentine belt routing diagram. Many cars come with a sticker in the engine bay that shows exactly how the serpentine belt is supposed to be routed through the various pulleys on the engine. If your vehicle does not have a sticker, you will need to find another way to remember how the belt should be run.
Using a 12 point, 17mm socket and a long handle ratchet (3/8″ drive), rotate accessory drive belt tensioner (5) counterclockwise until it contacts its stop. 20. Remove accessory drive belt (3). 21. Slowly rotate the belt tensioner (5) back into it’s freearm position. Was this answer helpful? I have a 2005 Jeep Cherokee 2.8 Ltr Diesel.
How often should I replace my serpentine belt?
The manufacturer recommends checking the serpentine belt every 7,500 miles or 6 months for potential replacement due to normal wear. Find the belt tensioner pulley. The tensioner pulley is generally between the crankshaft and a component toward the top of the hood area. Check the belt routing so you know how to replace the belt.
How do you change the belt tension on a Jeep Grand Cherokee?
For some older 6-cylinder models, the belt tension system is different. On these models, change the tension on the belt by loosening the two power steering bolts on the side of the power steering pump, then turn the adjustment bolt below the pump counter-clockwise to release tension on the belt.
How do you change power steering belt tension?
On these models, change the tension on the belt by loosening the two power steering bolts on the side of the power steering pump, then turn the adjustment bolt below the pump counter-clockwise to release tension on the belt. Follow the above steps for replacement using this alternate system.