How do you reset the oil light on a 2011 Jeep Compass?

How do you reset the oil light on a 2011 Jeep Compass?

Oil reset service light indicator Jeep Compass

1. Turn the ignition to run (one position before starting engine).
2. Fully depress the accelerator pedal slowly three times within 10 seconds.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.

How do you reset the change oil light on a Jeep Compass?

Jeep Compass Oil Change Required Service Maintenance Reminder Reset

1. Close all doors.
2. Set the gear to the PARK position.
3. Turn ignition to RUN position, don’t start the engine.
4. fully depress the accelerator pedal slowly three times within 10 seconds and the OIL CHANGE is reset.

How does the reset oil light work on a Jeep Compass?

Reset CHANgE OIL Message Jeep Compass. Your vehicle is equipped with an engine oil change indicator system. The “CHANgE OIL” message will flash in the instrument cluster odometer for approximately 12 seconds after a single chime has sounded to indicate the next scheduled oil change interval.

When to reset the oil change light on a Jeep Wrangler?

The Oil Change Light Reset Jeep Wrangler 2008 2009 2010 2011 will need to be performed after every oil change. If it is not reset the system will be unable to properly track when your next oil change is due. Below is the Oil Change Light Reset procedure for the Jeep Wrangler 2008 2009 2010 2011 .

How to reset service reminder on Jeep Compass?

Set the gear to the PARK position. Turn ignition to RUN position, don’t start the engine. fully depress the accelerator pedal slowly three times within 10 seconds and the OIL CHANGE is reset. Turn off the ignition, then s tart the engine to verify the service reminder has been reset.

How do I reset the oil change light?

If your vehicle has an ignition button, press the ENGINE START STOP button twice without touching the brake pedal Turn the ignition off and start the engine to verify the indicator has been reset. Repeat this procedure, if the message still illuminates when you start the engine.

How do reset change oil light?

For certain Jeep products, including the Wrangler, how to reset an oil change light is as follows: Insert the key into the ignition and turn it to the “on” position without starting the engine. Depress the gas pedal slowly three successive times within 10 seconds. At this point, the system should have reset. You can verify by turning the ignition off and then on again. If the light is still on, repeat the process.

How do you reset oil change indicator?

Hold the button down until the “Oil” icon or word starts to flash, or the indicator lights show some other sign of resetting. Some cars will flash the word “Reset,” or display the numeral “100” to show that 100 percent of oil life remains after the oil change. Turn the ignition off, wait a few moments, and then start the engine.

How do you turn off the change oil light?

Watch for the change oil light to flash. If it does not flash and remains on, turn the ignition key to the off position and then retry the procedure. After the change oil light flashes, it should go out. If the change oil remains on for five seconds (depending on the year and model Chevy), it may not have reset.

Can you reset the oil light in a Jeep Liberty?

• Turn the ignition to run (one position before starting engine).
• Fully depress the accelerator pedal slowly three times within 10 seconds.
• Turn the ignition off and then start the engine to verify the indicator has been reset.