Why is my hot air heater not working?
Heater not working. Not blowing hot air Guys, F55 cooper s, stopped blowing hot air today. Coolant level is fine, loads of posts online but all relating to the R56. Struggling to find the cause on the new mini’s.
What is the error code on an inverter heater?
The E4 Error Code is probably the most popular of the error codes which affect Inverter Heaters and this error can either be displayed from the moment the heater attempts to turn on, or it can occur intermittently, and sometimes the heater will work fine before eventually cutting out, with “E4” showing in the lcd display.
Why is the heater on my Mini Cooper not working?
As mine is only working on the passengers side I was wondering if there were 2 temperature controls and one is broken. Reading up it about it some BMWs have had similar problems from broken actuators and heater valves closed on one side.
How can I tell if my air heater is malfunctioning?
During operation, the air heater may malfunction. A malfunction is identified by the code displayed on the controller panel, see table below for code descriptions. The sensor sends a signal to shut down the heater.
Why does my diesel heater say error code 09?
Battery condition and feed cable size from battery can also cause problems. But do not worry , it will be worth it once you get it operating – best thing ever on a cold night. Could be faulty glow plug, couldn’t find PPAP but another no name variety had error code 09 Glow Plug faulty.
What does error code E15 mean on diesel heater?
The fan started but then stopped after about 10 seconds. Error code E15 came up and according to the manual this means ” Control Board fault”. Codes E13 to E16 are all listed as control Board faults but according to the download from Mike, E15 is a fuel pump error.
What is the fault code for a planar diesel heater?
Short circuit to the casing or open circuit in the wiring of the sensor. Check sensor as in 5.3 or 5.5, replace if necessary. Faulty sensor. Oxidation of contacts in the terminal block. Check overheat sensor circuit for an open. Remove oxidation from the connector contacts. See Fault Code 29.